pd104slg AZ Displays, Inc, pd104slg Datasheet - Page 19

• Manufacturer Part Number: pd104slg
• Description: Color Tft Lcd Module
• Manufacturer: AZ Displays, Inc

10. Handling Cautions
The information contained herein is the exclusive property of Prime View International Co., Ltd. and shall not be
distributed, reproduced, or disclosed in whole or in part without prior written permission of Prime View International Co.,
Ltd.
10-2) Precautions in mounting
10-3) Adjusting module
10-4) Polarizer mark
10-1) Mounting of module
10-5) Others
d) Please following the tear off direction as figure 10-1 to remove the protective film as
a) When metal part of the TFT-LCD module (shielding lid and rear case) is soiled,
b) Wipe off water drops or finger grease immediately. Long contact with water may
c) TFT-LCD module uses glass which breaks or cracks easily if dropped or bumped on hard surface.
d) Since CMOS LSI is used in the module. So take care of static electricity and
a) Adjusting volumes on the rear face of the module have been set optimally before shipment.
b) Therefore, do not change any adjusted values. If adjusted values are changed, the specifications
a) Do not expose the module to direct sunlight or intensive ultraviolet rays for many hours.
b) Store the module at a room temperature place.
c) The voltage of beginning electric discharge may over the normal voltage because of leakage
d) If LCD panel breaks, it is possibly that the liquid crystal escapes from the panel.
e) Observe all other precautionary requirements in handling general electronic components.
f)
b) Polarizer which is made of soft material and susceptible to flaw must be handled carefully.
c) Protective film (Laminator) is applied on surface to protect it against scratches and dirt.
a) Please power off the module when you connect the input/output connector.
The polarizer mark is to describe the direction of wide view angle film how to mach up with the
rubbing direction.
wipe it with soft dry cloth.
cause discoloration or spots.
Please handle with care.
earth yourself when handling.
described may not be satisfied.
current from approach conductor by to draw lump read lead line around.
Avoid putting it into eyes or mouth. When liquid crystal sticks on hands, clothes or feet. Wash it
out immediately with soap.
Please adjust the voltage of common electrode as material of attachment by 1 module.
slowly as possible, so that electrostatic charge can be minimized.
Figure 10-1 the way to peel off protective film
PD104SLG
P-511-525(V:2)
Page:19