cl211-0207-9-05 Hirose Electric, cl211-0207-9-05 Datasheet - Page 5

• Manufacturer Part Number: cl211-0207-9-05
• Description: Cd Crimp Type Connector
• Manufacturer: Hirose Electric

All non-RoHS products have been discontinued, or will be discontinued soon. Please check the products status on the Hirose website RoHS search at www.hirose-connectors.com, or contact your Hirose sales representative.
Assembling Procedure of Crimp Contact
Assembly Steps
Procedure for Contact Extraction
In case of extracting a contact from the housing in insertion error or in circuit change,
follow the steps as shown below:
Figure 1 illustrates a female contact. This also applies for a mate contact.
Pulling direction
(1) How to extract a contact
Male Contact
Insert a 1.1×0.5 mm thick board
into the lance-fixed-hole of the
housing as shown in Fig. 1 and
extract the contact by pulling
the wire.
1.1×0.5mm thick board
Female Contact
Fig. 1
Lance
about 1mm
(2) How to raise up a lance
When the extracted contact is in-
stalled again in the housing, please
raise up the contact lance as
shown in Fig. 2 and then insert it to
the housing.
Female housing
After assembling, pull
the wire slightly and
make sure if the
contact is mounted.
Fig. 2
04/2009
65