km29u64000it Samsung Semiconductor, Inc., km29u64000it Datasheet - Page 23

• Manufacturer Part Number: km29u64000it
• Description: 8m X 8 Bit Nand Flash Memory
• Manufacturer: Samsung Semiconductor, Inc.

BLOCK ERASE
The Erase operation is done on a block(8K Byte) basis. Block address loading is accomplished in two cycles initiated by an Erase
Setup command(60H). Only address A
block address loading initiates the internal erasing process. This two-step sequence of setup followed by execution command
ensures that memory contents are not accidentally erased due to external noise conditions.
At the rising edge of WE after the erase confirm command input, the internal write controller handles erase, erase-verify and pulse
repetition where required. When the erase operation is completed, the Write Status Bit(I/O 0) may be checked.
Figure 8 details the sequence.
R/B
I/O
READ STATUS
The device contains a Status Register which may be read to find out whether program or erase operation is completed, and whether
the program or erase operation is completed successfully. After writing 70H command to the command register, a read cycle outputs
the content of the Status Register to the I/O pins on the falling edge of CE or RE, whichever occurs last. This two line control allows
the system to poll the progress of each device in multiple memory connections even when R/B pins are common-wired. RE or CE
does not need to be toggled for updated status. Refer to table 2 for specific Status Register definitions. The command register
remains in Status Read mode until further commands are issued to it. Therefore, if the status register is read during a random read
cycle, a read command(00H or 50H) should be given before sequential page read cycle.
KM29U64000T, KM29U64000IT
Figure 8. Block Erase Operation
Table2. Status Register Definition
0
~
7
I/O
I/O
I/O
I/O
I/O
I/O
I/O
I/O
SR
60H
0
1
2
3
4
5
6
7
Block Add. : A
Address Input(2Cycle)
13
to A
9
~ A
22
22
is valid while A
Reserved for Future
Device Operation
Program / Erase
Write Protect
Status
Use
D0H
9
to A
23
t
12
BERS
is ignored. The Erase Confirm command(D0H) following the
"0" : Successful Program / Erase
"1" : Error in Program / Erase
"0"
"0"
"0"
"0"
"0"
"0" : Busy
"0" : Protected
70H
FLASH MEMORY
Definition
"1" : Not Protected
"1" : Ready
I/O
Fail
0
Pass