s82y-d60t ETC-unknow, s82y-d60t Datasheet - Page 11
![no-image](/images/no-image-200.jpg)
s82y-d60t
Manufacturer Part Number
s82y-d60t
Description
Switching Power Supply
Manufacturer
ETC-unknow
Datasheet
1.S82Y-D60T.pdf
(13 pages)
Precautions
J MOUNTING
Ventilation Holes and Adequate Air Circulation
•
•
•
Minimize Dirt and Dust
•
To extend its long-term reliability, provide adequate cooling
when installing the power supply.
When installing two or more power supplies side-by-side,
allow at least 20 mm (0.79) spacing between them, as shown
in the diagram below.
The ventilation holes in the front and back surfaces of the
unit must remain free of obstruction. The power supply is
cooled by air forced through it by the internal fan. Minimum
distances are indicated here.
Take precautions to minimize dirt, dust, and other airborne
debris which could interfere with the forced-air cooling.
300 W: 50 mm min.
600 W: 70 mm min.
20 mm min.
300 W: 40 mm min.
600 W:50 mm min.
Fan
J REPLACING THE FAN
Fan Alarm
•
Note: Replacement fan S82Y-DFAN can be ordered through
•
J TERMINAL EXPANSION BRACKET
For 600 W Power Supplies
•
Note: Refer to the Ordering Information section of this data
It is necessary to replace the internal fan when the fan alarm
output goes ON.
To replace the fan, remove the back cover as shown in the
diagram below.
When several loads need to be connected for 600-W Power
Supplies, use a terminal expansion bracket (as shown
below).
your dealer.
sheet.
Switching Power Supply
PCB
Body
Connector for
fan
S82Y-D60T
Brackets: 2
M4 x 8 terminal screws: 12
M5 x 12 terminal screws: 4
Fan
Back cover
S82D
11