thncf032mbai TOSHIBA Semiconductor CORPORATION, thncf032mbai Datasheet - Page 47

• Manufacturer Part Number: thncf032mbai
• Description: Thncfxxxmba/bai Series Compactflash Card Flash Technology Based With Interface Flash Memory Card.
• Manufacturer: TOSHIBA Semiconductor CORPORATION

Attention for Card Use
•
•
•
•
•
•
•
In the reset or power off, the information of all registers is cleared.
Notice that the card insertion/removal should not be executed during host is active, if the card is used in True
IDE mode.
After the card hard reset, soft reset, or power on reset, ATA reset, command applied the card cannot access
during +RDY / −BSY pin is “low” level. Flash card can’t be operated in this case.
Before the card insertion V
inseted, supply V
−OE must be kept at the V
kept constantly at the GND level in True IDE mode.
Do not turn off the power or remove THNCFxxxMBA/BAI Series from the slot before read/write operation is
complete. Avoid using THNCFxxxMBA/BAI Series when the battery is low. Power shortage, power failure and/or
removal of THNCFxxxMBA/BAI Series from the slot before read/write operation is complete may cause
malfunction of THNCFxxxMBA/BAI Series, data loss and/or damage to data.
Routine performance of backing-up data (or taking back-up of data) is strongly recommended.
CC
to the card.
CC
CC
level during power on reset in memory card mode and I/O card mode. OE must be
cannot be supplied to the card. After confirmation that −CD1, −CD2 pins are
Preliminary
THNCFxxxMBA/BAI Series
2002-10-20 47/48