ocx160 ETC-unknow, ocx160 Datasheet - Page 12

• Manufacturer Part Number: ocx160
• Description: Ocx160 Crosspoint Switch
• Manufacturer: ETC-unknow

OCX160 Crosspoint Switch—Preliminary Data Sheet
12
RCI[3:0]
Cycle 2
0110
0111
1000
1001
1010
1011
1100
1101
1110
1111
Output Port
Output Port
Output Port
RCA[6:0]
Address
Address
Address
Note – X = Don’t care.
X
X
X
X
Table 3
RCB[6:0]
Input Port
Input Port
Input Port
Input Port
Address
Address
Address
Address
X
X
X
RapidConfigure Programming Instructions (Continued)
Output Data
RCO[4:0]
[Rev. 1.6] 2/20/01
Disconnect Input and
ImpliedDisconnect
ImpliedDisconnect
Connect, without
Disconnect Input
Connect, with
Instruction
Reset All
Reserved
Reserved
Reserved
Reserved
Update
Output
Program the Global Update function
Readback (using RCO[4:0]) the status of
the input buffer specified in Cycle 1 by
RCA[6:0], the output buffer specified in
Cycle 1 by RCO[4:0] and the crosspoint
connect status.
See Table 4 for RCO[4:0] readback pin
assignment.
without the use of the UPDATE# pin.
Disconnect the crosspoint cells of the
input row location specified by
RCA[6:0].
Disconnect the crosspoint cell at the
input location specified by RCA[6:0] to
the output location specified by
RCB[6:0].
All other connections from the source
input address or to the same output
address remain the same as before.
Connect the crosspoint cell at the input
location specified by RCA[6:0] to the
output location specified by RCB[6:0].
All other connections from the same
input address or to the same output
address are set to no connect (NC).
Connect the crosspoint cell at the input
location specified by RCA[6:0] to the
output location specified by RCB[6:0].
All other connections from the same
input address remain the same as before.
Reset the switch matrix to no connects
(NC). Output Buffers default to flow-
through mode (OP) with output enable
set to always enabled (ON). Output
Buffer defaults to select Global Clock
(CLK) source even though mode is OP.
Description
I-Cube, Inc.