msm7716p Oki Semiconductor, msm7716p Datasheet - Page 5

• Manufacturer Part Number: msm7716p
• Description: Single Rail Linear Codec
• Manufacturer: Oki Semiconductor

FEDL7716P-01
OKI Semiconductor
MSM7716P
VFO
Receive filter output.
The output signal has an amplitude of 2.0 V
above and below the signal ground voltage when the digital signal of
PP
+3 dBm0 is input to PCMIN. VFO can drive a load of 20 k or more.
This output can be externally controlled in the level range of 0 to –28 dB in 4 dB increments.
During power saving or power down, VFO output is at the voltage level (V
/2) of SG with a high impedance
DD
state.
PWI, AOUT+, AOUT–
PWI is connected to the inverting input of the receive driver.
The receive driver output is connected to the AOUT– pin. Thus, a receive level can be adjusted with the pins PWI,
AOUT–, and VFO described above.
The output of AOUT+ is inverted with respect to the output of AOUT– with a gain of 1.
The output signal amplitudes are a maximum of 2.0 V
.
PP
These outputs, above and below the signal ground voltage (V
/2), can drive a load of a minimum of 1 k with
DD
push-pull driving (a load connected between AOUT+ and AOUT–).
The output amplitudes are 4 V
maximum during push-pull driving. These outputs can be mute controlled
PP
externally. These outputs are operational during power saving and output the SG voltage (V
/2) in the high
DD
impedance state.
AUXO
Auxiliary receive filter output.
The output signal is inverted with respect to the VFO output with a gain of 1. The output signal swings above and
below the SG voltage (V
/2), and can drive a minimum load of 0.5 k with respect to the SG voltage.
DD
The output can be mute controlled externally.
During power saving and power down, AUXO outputs the SG voltage (V
/2) in the high impedance state.
DD
BCLK
Shift clock signal input for PCMIN and PCMOUT.
The frequency is equal to the data rate. Setting this signal to logic “1” or “0” drives both transmit and receive
circuits to the power-saving state.
5/23