ak4633 AKM Semiconductor, Inc., ak4633 Datasheet - Page 52

• Manufacturer Part Number: ak4633
• Description: 16-bit ?? Mono Codec With Alc & Mic/spk-amp
• Manufacturer: AKM Semiconductor, Inc.

ASAHI KASEI
The power supply voltage for Speaker-Amp SVDD can be set to from 2.2V to 4.0V. However, SVDD should be set to
from 2.6V to 3.6V, when 8Ω dynamic speaker is connected. If SVDD is more than 3.6V when 8Ω dynamic speaker is
connected to the AK4633, the output of Speaker-Amp should be restricted in consideration of maximum power
dissipation.
The output signal from DAC is input to the Speaker-amp. This Speaker-amp is a mono output controlled by BTL and the
gain of Speaker-Amp is set by SPKG1-0 bits. The output voltage depends on AVDD and SPKG1-0 bits.
<Caution for using Piezo Speaker>
When a piezo speaker is used, resistances more than 10Ω should be inserted between SPP/SPN pins and speaker in series,
respectively, as shown in Figure 41. Zener diodes should be inserted between speaker and GND as shown in Figure 41, in
order to protect SPK-Amp of AK4633 from the power that the piezo speaker outputs when the speaker is pressured. Zener
diodes of the following Zener voltage should be used.
For example, Zener diode which Zener voltage is 3.9V(Min 3.7V, Max 4.1V) can be used.
MS0447-E-03
Speaker Output
Note 30. AVDD=3.3V. The output level is proportional to AVDD.
Note 31. The Gain with a reference of SPKG1-0 bits = “00”.
Note 32. The setting of SPKG1-0 bits = “01” is recommend when 8Ω dynamic speaker is connected.
92% of SVDD ≤ Zener voltage of Zener diodo(ZD of Figure 41) ≤ SVDD+0.3V
Ex) In case of SVDD = 3.8V : 3.5V ≤ ZD ≤ 4.1V
The SPK-Amp Power is 250mW at 8Ω Load Resistance and 4.0Vpp output level.
SPKG1-0 bits
00
01
10
11
Figure 41. Circuit of Speaker Output (using a piezo speaker)
SPK-Amp
Table 35. SPK-Amp Output Voltage and Gain
SPK-AMP Output Level[Vpp]
DAC =-4.1dBFS (Note 30)
- 52 -
SPP
SPN
3.17
4.00
5.03
6.33
≥10Ω
≥10Ω
ZD
ZD
(Note 31)
+2dB
+4dB
+6dB
Gain
0dB
[AK4633]
2006/04