scf5250 Freescale Semiconductor, Inc, scf5250 Datasheet - Page 3

• Manufacturer Part Number: scf5250
• Description: Scf5250 Integrated Coldfire Microprocessor Data Sheet
• Manufacturer: Freescale Semiconductor, Inc

1.2.3
The integrated EMAC unit provides a common set of DSP operations and enhances the integer multiply
instructions in the ColdFire architecture. The EMAC provides functionality in three related areas:
Multiplies of 16x16 and 32x32 with 48-bit accumulates are supported in addition to a full set of extensions
for signed and unsigned integers plus signed, fixed-point fractional input operands. The EMAC has a
single-clock issue for 32x32-bit multiplication instructions and implements a four-stage execution
pipeline.
1.2.4
The instruction cache improves system performance by providing cached instructions to the execution unit
in a single clock. The SCF5250 processor uses a 8K-byte, direct-mapped instruction cache to achieve 107
MIPS at 120 MHz. The cache is accessed by physical addresses, where each 16-byte line consists of an
address tag and a valid bit. The instruction cache also includes a bursting interface for 16-bit and 8-bit port
sizes to quickly fill cache lines.
1.2.5
The 128-KByte on-chip SRAM is available in two banks, SRAM0 (64K) and SRAM1 (64K). It provides
one clock-cycle access for the ColdFire core. This SRAM can store processor stack and critical code or
data segments to maximize performance. Memory in SRAM1 can be accessed under DMA.
1.2.6
The SCF5250 SDRAM controller provides a glueless interface for one bank of SDRAM up to 32 MB (256
Mbits). The controller supports a 16-bit data bus. A unique addressing scheme allows for increases in
system memory size without rerouting address lines and rewiring boards. The controller operates in page
mode, non-page mode, and burst-page mode and supports SDRAMS.
1.2.7
The SCF5250 provides a glueless interface to 16-bit port size SRAM, ROM, and peripheral devices with
independent programmable control of the assertion and negation of chip-select and write-enable signals.
The SCF5250 also supports bursting ROMs.
1.2.8
The bus interface controller transfers information between the ColdFire core or DMA and memory,
peripherals, or other devices on the external bus. The external bus interface provides 23 bits of address bus
Freescale Semiconductor
1. Faster signed and unsigned integer multiplies
2. New multiply-accumulate operations supporting signed and unsigned operands
3. New miscellaneous register operations
Enhanced Multiply and Accumulate Module (EMAC)
Instruction Cache
Internal 128-KByte SRAM
SDRAM Controller
System Interface
External Bus Interface
SCF5250 Integrated ColdFire® Microprocessor Data Sheet, Rev. 1.1
Introduction
3