mb90f352espmc1 Fujitsu Microelectronics, Inc., mb90f352espmc1 Datasheet - Page 3

• Manufacturer Part Number: mb90f352espmc1
• Description: 16-bit Proprietary Microcontrollers
• Manufacturer: Fujitsu Microelectronics, Inc.

• Sub clock pin (X0A, X1A)
• Timer
• FULL-CAN interface : 1 channel
• UART (LIN/SCI) : 2 channels
• I
• DTP/External interrupt : 8 channels, CAN wakeup : 1 channel
• Delay interrupt generator module
• 8/10-bit A/D converter : 15 channels
• Program patch function
• Capable of changing input voltage level for port
• Low voltage/CPU operation detection reset (devices with T-suffix)
• Dual operation Flash memory
• Supported T
2
C interface*
• Yes (using the external oscillation) : devices without S-suffix
• No (using the sub clock mode at internal CR oscillation) : devices with S-suffix
• Timebase timer, watch timer, watchdog timer : 1 channel
• 8/16-bit PPG timer : 8-bit × 10 channels or 16-bit × 6 channels
• 16-bit reload timer : 2 channels (only Evaluation products has 4 channels)
• 16- bit input/output timer
Up to 400 kbps transfer rate
Module for activation of extended intelligent I/O service (EI
external input.
Generates interrupt request for task switching.
• Conversion time : 3 µs (at 24-MHz machine clock, including sampling time)
The maximum operating frequency is 24 MHz*
• Compliant with CAN standard Version2.0 Part A and Part B
• 16 message buffers are built-in
• CAN wake-up function
• Equipped with full-duplex double buffer
• Clock-asynchronous or clock-synchronous serial transmission is available.
• Resolution is selectable between 8-bit and 10-bit.
• Activation by external trigger input is allowed.
• Address matching detection for 6 address pointers.
• Automotive/CMOS-Schmitt (initial level is Automotive in single chip mode)
• TTL level (corresponds to external bus pins only, initial level of these pins is TTL in external bus mode)
• Detects low voltage (4.0 V ± 0.3 V) and resets automatically
• Resets automatically when program is runaway and counter is not cleared within interval time
• Erase/write and read can be executed in the different bank (Upper Bank/Lower Bank) at the same time.
- 16-bit free-run timer : 2 channels (FRT0 : ICU0/1, FRT1 : ICU4/5/6/7, OCU4/5/6/7)
- 16- bit input capture: (ICU) : 6 channels
- 16-bit output compare : (OCU) : 4 channels
(approx. 262 ms : external 4 MHz)
A
1
= + 125 °C
: 1 channel
2
: (at T
A
= +125 °C) .
2
OS), DMA, and generation of external interrupt by
MB90350E Series
(Continued)
3