mb95f156npmt Fujitsu Microelectronics, Inc., mb95f156npmt Datasheet - Page 28

• Manufacturer Part Number: mb95f156npmt
• Description: 8-bit Microcontroller Cmos 2 F2mc-8fx Mb95150m Series
• Manufacturer: Fujitsu Microelectronics, Inc.

28
MB95150M Series
(Continued)
*1 : The parameter is based on V
*2 : V0 to V3 should not exceed V
*3 : V
*4 : Applicable to pins : P00 to P07, P10 to P14, P60 to P67, P90 to P95, PA0 to PA3, PB0 to PB7
WARNING: Semiconductor devices can be permanently damaged by application of stress (voltage, current,
• Input/Output Equivalent circuits
to/from an input is limited by some means with external components, the I
• Use within recommended operating conditions.
• Use at DC voltage (current).
• +B signal is an input signal that exceeds V
• The value of the limiting resistance should be set so that when the + B signal is applied the input current
• Note that when the microcontroller drive current is low, such as in the power saving modes, the +B input
• Note that if the + B signal is inputted when the microcontroller power supply is off (not fixed at 0 V), the power
• Note that if the + B input is applied during power-on, the power supply is provided from the pins and the
• Care must be taken not to leave the + B input pin open.
• Note that analog system input/output pins other than the A/D input pins (LCD drive pins, etc.) cannot accept
• Sample recommended circuits :
I
and Vo should not exceed V
resistance placed between the + B signal and the microcontroller.
to the microcontroller pin does not exceed rated values, either instantaneously or for prolonged periods.
potential may pass through the protective diode and increase the potential at the V
other devices.
supply is provided from the pins, so that incomplete operation may result.
resulting power supply voltage may not be sufficient to operate the power-on reset.
+ B signal input.
temperature, etc.) in excess of absolute maximum ratings. Do not exceed these ratings.
+ B input (0 V to 16 V)
SS
CC
CC
= 0.0 V.
+ 0.3 V. V
+ 0.3 V.
resistance
I
Limiting
must not exceed the rating voltage. However, if the maximum current
CC
voltage. The + B signal should always be applied a limiting
Protective diode
R
Vcc
CLAMP
P-ch
N-ch
rating supersedes the V
CC
pin, and this affects
I
rating.