lm77cimmx-5 National Semiconductor Corporation, lm77cimmx-5 Datasheet - Page 8

• Manufacturer Part Number: lm77cimmx-5
• Description: 9-bit Sign Digital Temperature Sensor And Thermal Window Comparator With Two-wire Interface
• Manufacturer: National Semiconductor Corporation

www.national.com
1.0 Functional Description
terrupts just after reprogramming setpoints. Typically, sys-
tem Interrupt inputs are masked prior to reprogramming trip
points. By doing a read just after resetting trip points, but
prior to unmasking, unexpected Interrupts are prevented.
Avoid programming setpoints so close that their hysteresis
values overlap. An example would be that with a T
of 2˚C then setting T
other will violate this restriction. To be more specific, with
T
equal to, or higher than 60˚C this restriction is violated.
1.2 DEFAULT SETTINGS
The LM77 always powers up in a known state. LM77 power
up default conditions are:
1. Comparator Interrupt Mode
2. T
3. T
4. T_CRIT set to 80˚C
5. T
6. INT and T_CRIT_A active low
7. Pointer set to “00”; Temperature Register
The LM77 registers will always reset to these default values
when the power supply voltage is brought up from zero volts
as the supply crosses the voltage level plotted in the follow-
ing curve. The LM77 registers will reset again when the
power supply drops below the voltage plotted in this curve.
HYST
LOW
HIGH
HYST
set to 2˚C assume T
set to 10˚C
set to 64˚C
set to 2˚C
HIGH
and T
HIGH
set to 64˚C. If T
LOW
to within 4˚C of each
(Continued)
HYST
LOW
is set
value
8
Average Power on Reset Voltage
vs Temperature
1.3 SERIAL BUS INTERFACE
The LM77 operates as a slave on the Serial Bus, so the SCL
line is an input (no clock is generated by the LM77) and the
SDA line is a bi-directional serial data line. According to
Serial Bus specifications, the LM77 has a 7-bit slave ad-
dress. The five most significant bits of the slave address are
hard wired inside the LM77 and are “10010”. The two least
significant bits of the address are assigned to pins A1–A0,
and are set by connecting these pins to ground for a low, (0);
or to +V
Therefore, the complete slave address is:
MSB
1
S
for a high, (1).
0
0
1
0
DS100136-18
A1
LSB
A0