lx1663 Microsemi Corporation, lx1663 Datasheet - Page 7

• Manufacturer Part Number: lx1663
• Description: Single-chip Programmable Controllers With 5-bit
• Manufacturer: Microsemi Corporation

Name
Pin
LX1662
Pin #
LX1663
Pin #
Description
Soft-Start pin, internally connected to the non-inverting input of the error comparator.
Inverting input of the error comparator.
Output voltage. Connected to non-inverting input of the current-sense comparator.
Voltage Identification pin (LSB) input used to set output voltage.
Voltage Identification pin (2
Voltage Identification pin (3
Voltage Identification pin (4
Voltage Identification pin (MSB) input. This pin is also the range select pin — when low
(CLOSED), output voltage is set to between 1.30 and 2.05V in 0.05V increments. When high
(OPEN), output is adjusted from 2.0 to 3.5V in 0.1V increments.
Open collector output pulls low when the output voltage is out of limits.
SCR driver goes high when the processor's supply is over specified voltage limits.
The off-time is programmed by connecting a timing capacitor to this pin.
This is the (12V) supply to the IC, as well as gate drive to the bottom FET.
This is the gate drive to the bottom FET. Leave open in non-synchronous operation (when bottom
FET is replaced by a Schottky diode).
Both power and signal ground of the device.
Gate drive for top MOSFET.
This pin is a separate power supply input for the top drive. Can be connected to a charge pump
when only 12V is available.
nd
rd
th
SB) input.
SB) input.
SB) input.
LX1662/62A, LX1663/63A
7