zxld1615 Zetex Semiconductors plc., zxld1615 Datasheet - Page 7

• Manufacturer Part Number: zxld1615
• Description: Adjustable Dc-dc Boost Converter With Internal Switch In Tsot23-5
• Manufacturer: Zetex Semiconductors plc.

V
APPLICATIONS
Setting output voltage
The ZXLD1615 has an adjustable output voltage
allowing the end user maximum flexibility. To set the
output voltage a potential divider network is needed
(see R1 and R2 in typical applications circuit).
The output voltage is determined by the equation:
where VFB = 1.025V.
The following table gives suggested values for
various output voltages.
Output voltage can be adjusted from V
maximum output voltage rating of the internal
switch, 30V.
Once the nominal output voltage has been set, it can
be adjusted to a lower value by applying a pulse
width modulated (PWM) control signal to the EN pin.
PWM adjustment permits the device to be turned on
and the output voltage set by a single logic signal
applied to the EN pin. No external resistors are
required and the amplitude of the control signal is
not critical, providing it conforms to the limits
defined in the electrical characteristics.
ISSUE 3 - AUGUST 2004
Required
output voltage
5V
12V
18V
21V
25V
28V
OUT
=
V
FB
⎛
⎜
⎝
1
+
R
R
2
1
⎞
⎟
⎠
R1
270K
91K
60K
51K
43K
39K
R2
1M
1M
1M
1M
1M
1M
IN
+ V
F
to the
7
1) PWM output voltage adjustment (analogue mode)
During this mode of operation the device operation is
continuous, providing a low ripple output voltage
(V
the logic signal applied to the EN pin according to the
relationship:
V
Square wave signals applied to the EN pin, for
example, will turn the device on and produce a
nominal regulated output of 13.5V.
The ZXLD1615 contains a timing circuit that switches
the device on a few microseconds after the
application of a rising edge to EN and turns it back
off again nominally 120µs after the falling edge of
EN. For continuous PWM mode operation, the
frequency of the control signal must therefore be
maintained above 10kHz at all times, to prevent the
internal delay circuit from timing out and switching
the device into standby mode. The maximum
frequency applied to EN should be limited to 100kHz
to minimize errors due to internal switching delays
2) PWM output voltage adjustment (gated mode)
This method of adjustment can be used in
applications where the output ripple is less important
than the supply current. The method of adjustment is
the same as in 1) above, however, during this mode
of operation, the device is gated on and off,
providing an average output voltage (V
proportional to the duty cycle (D) of the logic signal
applied to the EN pin according to the relationship:
V
The ripple on this voltage will be determined by the
size of the output capacitor.
The output voltage can be adjusted all the way down
to the input voltage by either method of PWM
control, but for best results, the duty cycle range
should be kept within the specified range. Lower duty
cycles will result in increased output ripple and
non-linearity in the relationship between duty cycle
and output voltage. If a greater control range is
required, the nominal output can be reduced by the
use of external resistors before the PWM signal is
applied.
Minimizing output voltage ripple
For applications requiring lower output ripple it may
be necessary to add a small ceramic capacitor in
parallel with R2. A value of 4.7pF is suitable for most
output ranges.
OUT
OUT(AVG)
OUT
) directly proportional to the duty cycle (D) of
= D x V
= D x V
OUT(nom)
OUT(nom)
ZXLD1615
S E M I C O N D U C T O R S
OUT
) directly