at17f32a ATMEL Corporation, at17f32a Datasheet - Page 5

• Manufacturer Part Number: at17f32a
• Description: At17f32a Fpga Configuration Flash Memory
• Manufacturer: ATMEL Corporation

5.4
5.5
5.6
5.7
5.8
3489C–CNFG–08/07
PAGESEL[1:0]
RESET/OE
nCS
GND
nCASC
(1)
(1)
(2)
Page select inputs. Used to determine which of the 4 memory pages are targeted during a serial
configuration download. The address space for each of the pages is shown in
SER_EN is Low (ISP mode) these pins have no effect.
Table 5-1.
Output Enable (active High) and RESET (active Low) when SER_EN is High. A Low level on
RESET/OE resets both the address and bit counters. A High level (with nCS Low) enables the
data output driver.
Chip Enable input (active Low). A Low level (with OE High) allows DCLK to increment the
address counter and enables the data output driver. A High level on nCS disables both the
address and bit counters and forces the device into a low-power standby mode. Note that this
pin will not enable/disable the device in the 2-wire Serial Programming mode (SER_EN Low).
Ground pin. A 0.2 µF decoupling capacitor between V
Cascade Select Output (when SER_EN is High). This output goes Low when the internal
address counter has reached its maximum value. If the PAGE_EN input is set High, the maxi-
mum value is the highest address in the selected partition. The PAGESEL[1:0] inputs are used
to make the 4 partition selections. If the PAGE_EN input is set Low, the device is not partitioned
and the address maximum value is the highest address in the device, see
In a daisy chain of AT17FxxA Series devices, the nCASC pin of one device must be connected
to the nCS input of the next device in the chain. It will stay Low as long as nCS is Low and OE is
High. It will then follow nCS until OE goes Low; thereafter, nCASC will stay High until the entire
EEPROM is read again.
Notes:
Paging Decodes
PAGESEL = 00, PAGE_EN = 1
PAGESEL = 01, PAGE_EN = 1
PAGESEL = 10, PAGE_EN = 1
PAGESEL = 11, PAGE_EN = 1
PAGESEL = XX, PAGE_EN = 0
1. This pin has an internal 20 KΩ pull-up resistor.
2. This pin has an internal 30 KΩ pull-down resistor.
Address Space
CC
AT17F32A (32 Mbits)
000000 – 07FFFFh
080000 – 0FFFFFh
100000 – 17FFFFh
180000 – 1FFFFFh
000000 – 1FFFFFh
and GND is recommended.
Table 5-1 on page
AT17F32A
Table
5-1. When
5.
5