at17f080 ATMEL Corporation, at17f080 Datasheet - Page 8
![no-image](/images/manufacturer_photos/0/0/79/atmel_corporation_sml.jpg)
at17f080
Manufacturer Part Number
at17f080
Description
8 Mbit In-system Programable Prom
Manufacturer
ATMEL Corporation
Datasheet
1.AT17F080.pdf
(19 pages)
Available stocks
Company
Part Number
Manufacturer
Quantity
Price
Company:
Part Number:
AT17F080
Manufacturer:
CIRRUS
Quantity:
16
Part Number:
at17f080A-30CU
Manufacturer:
ATMEL/爱特梅尔
Quantity:
20 000
6. FPGA Master Serial Mode Summary
7. Control of Configuration
8. Cascading Serial Configuration Devices
9. Programming Mode
8
AT17F040/080
The I/O and logic functions of any SRAM-based FPGA are established by a configuration pro-
gram. The program is loaded either automatically upon power-up, or on command, depending
on the state of the FPGA mode pins. In Master mode, the FPGA automatically loads the config-
uration program from an external memory. The AT17F Serial Configuration PROM has been
designed for compatibility with the Master Serial mode.
This document discusses the Atmel AT40K, AT40KAL and AT94KAL applications as well as Xil-
inx applications.
Most connections between the FPGA device and the AT17F Serial Configurator PROM are sim-
ple and self-explanatory.
For multiple FPGAs configured as a daisy-chain, or for FPGAs requiring larger configuration
memories, cascaded configurators provide additional memory.
After the last bit from the first configurator is read, the clock signal to the configurator asserts its
CEO output Low and disables its DATA line driver. The second configurator recognizes the Low
level on its CE input and enables its DATA output.
After configuration is complete, the address counters of all cascaded configurators are reset if
the RESET/OE on each configurator is driven to its active (Low) level.
If the address counters are not to be reset upon completion, then the RESET/OE input can be
tied to its inactive (High) level.
The programming mode is entered by bringing SER_EN Low. In this mode the chip can be pro-
grammed by the 2-wire serial bus. The programming is done at V
super voltages are generated inside the chip. The AT17F parts are read/write at 3.3V nominal.
Refer to the AT17F Programming Specification available on the Atmel web site
(www.atmel.com) for more programming details. AT17F devices are supported by the Atmel
ATDH2200 programming system along with many third party programmers.
• The DATA output of the AT17F Series Configurator drives DIN of the FPGA devices.
• The master FPGA CCLK output drives the CLK input of the AT17F Series Configurator.
• The CEO output of any AT17F Series Configurator drives the CE input of the next
• SER_EN must be connected to V
• The READY pin is available as an open-collector indicator of the device’s reset status; it is
• PAGE_EN must be held Low if download paging is not desired. The PAGESEL[1:0] inputs
Configurator in a cascade chain of configurator devices.
driven Low while the device is in its power-on reset cycle and released (tri-stated) when the
cycle is complete.
must be tied off High or Low. If paging is desired, PAGE_EN must be High and the PAGESEL
pins must be set to High or Low such that the desired page is selected, see
page
6.
CC
(except during ISP).
CC
supply only. Programming
Table 5-2 on
3039K–CNFG–2/08