is24c32a-2zl Integrated Silicon Solution, Inc., is24c32a-2zl Datasheet - Page 4
![no-image](/images/no-image-200.jpg)
is24c32a-2zl
Manufacturer Part Number
is24c32a-2zl
Description
64k-bit/32k-bit 2-wire Serial Cmos Eeprom
Manufacturer
Integrated Silicon Solution, Inc.
Datasheet
1.IS24C32A-2ZL.pdf
(19 pages)
IS24C32A/B
IS24C64A/B
DEVICE OPERATION
IS24CXX features serial communication and supports a bi-
directional 2-wire bus transmission protocol called I
2-WIRE BUS
The two-wire bus is defined as a Serial Data line (SDA), and
a Serial Clock line (SCL). The protocol defines any device
that sends data onto the SDA bus as a transmitter, and the
receiving devices as receivers. The bus is controlled by a
Master device that generates the SCL, controls the bus
access, and generates the Stop and Start conditions. The
IS24CXX is the Slave device on the bus.
The Bus Protocol:
– Data transfer may be initiated only when the bus is not
– During a data transfer, the SDA line must remain stable
The state of the SDA line represents valid data after a Start
condition. The SDA line must be stable for the duration of
the High period of the clock signal. The data on the SDA
line may be changed during the Low period of the clock
signal. There is one clock pulse per bit of data. Each data
transfer is initiated with a Start condition and terminated
with a Stop condition.
Start Condition
The Start condition precedes all commands to the device
and is defined as a High to Low transition of SDA when SCL
is High. The EEPROM monitors the SDA and SCL lines and
will not respond until the Start condition is met.
4
busy
whenever the SCL line is high. Any changes in the SDA
line while the SCL line is high will be interpreted as a
Start or Stop condition.
2
C
TM
.
Stop Condition
The Stop condition is defined as a Low to High transition of
SDA when SCL is High. All operations must end with a Stop
condition.
Acknowledge (ACK)
After a successful data transfer, each receiving device is
required to generate an ACK. The Acknowledging device
pulls down the SDA line.
Reset
The
wire bus transmission is accidentally interrupted (eg. a
power loss), or needs to be terminated mid-stream. The
reset is caused when the Master device creates a Start
condition. To do this, it may be necessary for the Master
device to monitor the SDA line while cycling the SCL up
to nine times. (For each clock signal transition to High,
the Master checks for a High level on SDA.)
Standby Mode
Power consumption is reduced in standby mode. The
IS24CXX will enter standby mode: a) At Power-up, and
remain in it until SCL or SDA toggles; b) Following the Stop
signal if a no write operation is initiated; or c) Following any
internal write operation.
IS24CXX
Integrated Silicon Solution, Inc. | www.issi.com
contains a reset function in case the 2-
01/04/08
Rev. D