m95512-r STMicroelectronics, m95512-r Datasheet - Page 13

no-image

m95512-r

Manufacturer Part Number
m95512-r
Description
512kbit Serial Spi Bus Eeprom With High Speed Clock
Manufacturer
STMicroelectronics
Datasheet

Available stocks

Company
Part Number
Manufacturer
Quantity
Price
Part Number:
m95512-rDW6P
Manufacturer:
ST
0
Part Number:
m95512-rDW6TP
Manufacturer:
STMicroelectronics
Quantity:
150 141
Part Number:
m95512-rDW6TP
Manufacturer:
ST
Quantity:
8 963
Part Number:
m95512-rDW6TP
Manufacturer:
ST
0
Part Number:
m95512-rDW6TP
Manufacturer:
ST
Quantity:
20 000
Part Number:
m95512-rMB6TG
Manufacturer:
ST
Quantity:
8 000
Part Number:
m95512-rMB6TG
Manufacturer:
ST
0
Part Number:
m95512-rMN6TP
Manufacturer:
TDK
Quantity:
324
Part Number:
m95512-rMN6TP
Manufacturer:
ST
0
M95512-W, M95512-R
4.1.4
4.2
4.3
Power-down
At Power-down (continuous decrease in V
operating voltage to below the Power On Reset threshold voltage, the device stops
responding to any instruction sent to it.
During Power-down, the device must be deselected and in Standby Power mode (that is
there should be no internal Write cycle in progress). Chip Select (S) should be allowed to
follow the voltage applied on V
Active Power and Standby Power modes
When Chip Select (S) is Low, the device is selected, and in the Active Power mode. The
device consumes I
When Chip Select (S) is High, the device is deselected. If a Write cycle is not currently in
progress, the device then goes in to the Standby Power mode, and the device consumption
drops to I
Hold condition
The Hold (HOLD) signal is used to pause any serial communications with the device without
resetting the clocking sequence.
During the Hold condition, the Serial Data Output (Q) is high impedance, and Serial Data
Input (D) and Serial Clock (C) are Don’t Care.
To enter the Hold condition, the device must be selected, with Chip Select (S) Low.
Normally, the device is kept selected, for the whole duration of the Hold condition.
Deselecting the device while it is in the Hold condition, has the effect of resetting the state of
the device, and this mechanism can be used if it is required to reset any processes that had
been in progress.
The Hold condition starts when the Hold (HOLD) signal is driven Low at the same time as
Serial Clock (C) already being Low (as shown in
The Hold condition ends when the Hold (HOLD) signal is driven High at the same time as
Serial Clock (C) already being Low.
Figure 5
with Serial Clock (C) being Low.
also shows what happens if the rising and falling edges are not timed to coincide
CC1
.
CC
, as specified in
CC
.
Table
CC
12.
), as soon as V
Figure
5).
CC
drops from the normal
Operating features
13/39

Related parts for m95512-r