lm2901ep National Semiconductor Corporation, lm2901ep Datasheet - Page 6
![no-image](/images/no-image-200.jpg)
lm2901ep
Manufacturer Part Number
lm2901ep
Description
Low Power Low Offset Voltage Quad Comparators
Manufacturer
National Semiconductor Corporation
Datasheet
1.LM2901EP.pdf
(17 pages)
www.national.com
Application Hints
The LM2901EP is a high gain, wide bandwidth device which,
like most comparators, can easily oscillate if the output lead
is inadvertently allowed to capacitively couple to the inputs
via stray capacitance. This shows up only during the output
voltage transition intervals as the comparator changes
states. Power supply bypassing is not required to solve this
problem. Standard PC board layout is helpful as it reduces
stray input-output coupling. Reducing this input resistors to
adding even a small amount (1 to 10 mV) of positive feed-
back (hysteresis) causes such a rapid transition that oscilla-
tions due to stray feedback are not possible. Simply socket-
ing the IC and attaching resistors to the pins will cause
input-output oscillations during the small transition intervals
unless hysteresis is used. If the input signal is a pulse
waveform, with relatively fast rise and fall times, hysteresis is
not required.
All pins of any unused comparators should be tied to the
negative supply.
The bias network of the LM2901EP series establishes a
drain current which is independent of the magnitude of the
power supply voltage over the range of from 2 V
V
It is usually unnecessary to use a bypass capacitor across
the power supply line.
Typical Applications
<
DC
10 kΩ reduces the feedback signal levels and finally,
.
Basic Comparator
AND Gate
20113903
(V
+
= 5.0 V
DC
) (Note 15)
DC
20113908
to 30
Driving CMOS
6
The differential input voltage may be larger than V
damaging the device. Protection should be provided to pre-
vent the input voltages from going negative more than −0.3
V
in the applications section.
The output of the LM2901EP is the uncommitted collector of
a grounded-emitter NPN output transistor. Many collectors
can be tied together to provide an output OR’ing function. An
output pull-up resistor can be connected to any available
power supply voltage within the permitted supply voltage
range and there is no restriction on this voltage due to the
magnitude of the voltage which is applied to the V
of the LM2901EP package. The output can also be used as
a simple SPST switch to ground (when a pull-up resistor is
not used). The amount of current which the output device
can sink is limited by the drive available (which is indepen-
dent of V
current limit is reached (approximately 16 mA), the output
transistor will come out of saturation and the output voltage
will rise very rapidly. The output saturation voltage is limited
by the approximately 60Ω R
low offset voltage of the output transistor (1 mV) allows the
output to clamp essentially to ground level for small load
currents.
DC
(at 25˚C). An input clamp diode can be used as shown
+
20113904
) and the β of this device. When the maximum
OR Gate
SAT
of the output transistor. The
Driving TTL
+
+
terminal
without
20113909
20113905