lt5568 Linear Technology Corporation, lt5568 Datasheet - Page 7

• Manufacturer Part Number: lt5568
• Description: 700mhz To 1050mhz High Linearity Direct Quadrature Modulator
• Manufacturer: Linear Technology Corporation

PI FU CTIO S
EN (Pin 1): Enable Input. When the enable pin voltage is
higher than 1V, the IC is turned on. When the input voltage
is less than 0.5V, the IC is turned off.
GND (Pins 2, 4, 6, 9, 10, 12, 15): Ground. Pins 6, 9, 15
and 17 (exposed pad) are connected to each other inter-
nally. Pins 2 and 4 are connected to each other internally
and function as the ground return for the LO signal. Pins
10 and 12 are connected to each other internally and
function as the ground return for the on-chip RF balun.
For best RF performance, pins 2, 4, 6, 9, 10, 12, 15 and
the Exposed Pad 17 should be connected to the printed
circuit board ground plane.
LO (Pin 3): LO Input. The LO input is an AC-coupled single-
ended input with approximately 50Ω input impedance at
RF frequencies. Externally applied DC voltage should be
within the range –0.5V to V
turning on ESD protection diodes.
U
U
U
CC
+ 0.5V in order to avoid
BBPQ, BBMQ (Pins 7, 5): Baseband Inputs for the Q-chan-
nel, each 50Ω input impedance. Internally biased at about
0.54V. Applied voltage must stay below 2.5V.
V
nected to each other internally. It is recommended to use
0.1µF capacitors for decoupling to ground on each of
these pins.
RF (Pin 11): RF Output. The RF output is an AC-coupled
single-ended output with approximately 50Ω output im-
pedance at RF frequencies. Externally applied DC voltage
should be within the range –0.5V to V
to avoid turning on ESD protection diodes.
BBPI, BBMI (Pins 14, 16): Baseband Inputs for the
I-channel, each with 50Ω input impedance. Internally biased
at about 0.54V. Applied voltage must stay below 2.5V.
Exposed Pad (Pin 17): Ground. This pin must be soldered
to the printed circuit board ground plane.
CC
(Pins 8, 13): Power Supply. Pins 8 and 13 are con-
CC
LT5568-2
+ 0.5V in order
55682f
7