psf2115 ETC-unknow, psf2115 Datasheet - Page 203
psf2115
Manufacturer Part Number
psf2115
Description
Isdn Adapter Circuit Ipac
Manufacturer
ETC-unknow
Datasheet
1.PSF2115.pdf
(317 pages)
Available stocks
Company
Part Number
Manufacturer
Quantity
Price
Part Number:
psf21150FV1.4
Manufacturer:
INFINEON/英飞凌
Quantity:
20 000
- Current page: 203 of 317
- Download datasheet (4Mb)
Semiconductor Group
3.6.4.2
The transition criteria used by the IPAC are described in the following sections. They are
grouped into:
– C/I commands
– Pin states
– Events on the S/T-interface.
C/I Commands
AR
ARL
DC
DR
RES
TM1
TM2
Pin States
Pin-RES
S/T-Interface Events
I0
I0
I3
I3
INFO 0 detected
Level detected (signal different to I0)
INFO 3 detected
Any INFO other than INFO 3
LT-S Mode Transition Criteria
Activation Request. This command is used to start an exchange initiated
activation.
Activation request loop. The IPAC is requested to operate an analog loop-
back close to the S/T-interface.
Deactivation Confirmation. Transfers the LT-S into a deactivated state in
which it can be activated from a terminal (detection of INFO 0 enabled).
Deactivation Request. Initiates a complete deactivation from the exchange
side by transmitting INFO 0. Unconditional command.
Please refer to section 3.6.3.2 (C/I command description) for details.
Test Mode 1. Transmission of single pulses on the S/T-interface. The
pulses are transmitted with alternating polarity at a frequency of 2 kHz.
TM1 is an unconditional command.
Test Mode 2. Transmission of continuous pulses on the S/T-interface. The
pulses are sent with alternating polarity at a rate of 96 kHz. TM2 is an
unconditional command.
Pin Reset. Please refer to section 3.6.3.2 (pin states).
203
Operational Description
PSB 2115
PSF 2115
11.97
Related parts for psf2115
Image
Part Number
Description
Manufacturer
Datasheet
Request
R
Part Number:
Description:
Manufacturer:
ETC-unknow
Datasheet:
Part Number:
Description:
Manufacturer:
ETC-unknow
Datasheet: