adg709cru-reel Analog Devices, Inc., adg709cru-reel Datasheet - Page 11

• Manufacturer Part Number: adg709cru-reel
• Description: Cmos, 1.8 V To 5.5 V/?2.5 V, 3 ? Low Voltage 4-/8-channel Multiplexers
• Manufacturer: Analog Devices, Inc.

TERMINOLOGY
V
Most positive power supply potential.
VSS
Most negative power supply in a dual-supply application. In
single-supply applications, this should be tied to ground at the
device.
GND
Ground (0 V) reference.
S
Source terminal. Can be an input or output.
D
Drain terminal. Can be an input or output.
Ax
Logic control input.
EN
Active high enable.
R
Ohmic resistance between D and S.
R
Flatness is defined as the difference between the maximum and
minimum value of on resistance as measured over the specified
analog signal range.
I
Source leakage current with the switch off.
I
Drain leakage current with the switch off.
I
Channel leakage current with the switch on.
V
Analog voltage on Terminal D and Terminal S.
C
Off switch source capacitance. Measured with reference to
ground.
C
Off switch drain capacitance. Measured with reference to
ground.
C
On switch capacitance. Measured with reference to ground.
S
D
D
ON
FLAT(ON)
S
D
D
DD
D
, I
(OFF)
(OFF)
, C
(OFF)
(V
(OFF)
S
(ON)
S
S
)
(ON)
Rev. B | Page 11 of 20
C
Digital input capacitance.
t
Delay time measured between the 50% and 90% points of the
digital inputs and the switch on condition when switching from
one address state to another.
t
Delay time between the 50% and 90% points of the EN digital
input and the switch on condition.
t
Delay time between the 50% and 90% points of the EN digital
input and the switch off condition.
t
Off time measured between the 80% points of both switches
when switching from one address state to another.
Off Isolation
A measure of unwanted signal coupling through an off switch.
Crosstalk
A measure of unwanted signal that is coupled through from one
channel to another as a result of parasitic capacitance.
Charge
A measure of the glitch impulse transferred from injection of
the digital input to the analog output during switching.
Bandwidth
The frequency at which the output is attenuated by 3 dB.
On Response
The frequency response of the on switch.
On Loss
The loss due to the on resistance of the switch.
V
Maximum input voltage for Logic 0.
V
Minimum input voltage for Logic 1.
I
Input current of the digital input.
I
Positive supply current.
I
Negative supply current.
TRANSITION
ON
OFF
OPEN
INL
DD
SS
IN
INL
INH
(EN)
(EN)
(I
INH
)
ADG708/ADG709