sak-xe164km-48fxxl Infineon Technologies Corporation, sak-xe164km-48fxxl Datasheet - Page 76

• Manufacturer Part Number: sak-xe164km-48fxxl
• Description: 16-bit Single-chip Real Time Signal Controller
• Manufacturer: Infineon Technologies Corporation

XE164FM, XE164GM, XE164HM, XE164KM
XE166 Family Derivatives / Base Line
Electrical Parameters
4.2
DC Parameters
These parameters are static or average values that may be exceeded during switching
transitions (e.g. output current).
The XE164xM can operate within a wide supply voltage range from 3.0 V to 5.5 V.
However, during operation this supply voltage must remain within 10 percent of the
selected nominal supply voltage. It cannot vary across the full operating voltage range.
Because of the supply voltage restriction and because electrical behavior depends on
the supply voltage, the parameters are specified separately for the upper and the lower
voltage range.
During operation, the supply voltages may only change with a maximum speed of
dV/dt < 1 V/ms.
Leakage current is strongly dependent on the operating temperature and the voltage
level at the respective pin. The maximum values in the following tables apply under worst
case conditions, i.e. maximum temperature and an input level equal to the supply
voltage.
The value for the leakage current in an application can be determined by using the
respective leakage derating formula (see tables) with values from that application.
The pads of the XE164xM are designed to operate in various driver modes. The DC
parameter specifications refer to the pad current limits specified in
Section
4.6.4.
Data Sheet
76
V2.0, 2009-03