hcpl-0560 ETC-unknow, hcpl-0560 Datasheet - Page 7

• Manufacturer Part Number: hcpl-0560
• Description: Dual Channel Bi-directional High Speed Optoisolators
• Manufacturer: ETC-unknow

-
* The Input–Output Momentary Withstand Voltage is a dielectric voltage rating that should not be interpreted as an input-output
Package Characteristics
All typical values at T
Notes:
10. In accordance with UL 1577, each optocoupler is proof tested by applying an insulation test voltage 3000 Vrms for 1 second
1. Derate linearly above 90˚C free-air temperature at a rate of 3.0 mW/˚C.
2. In the V
3. Each channel.
4. DC CURRENT TRANSFER RATIO is defined as the ratio of output collector current, I
5. The 1.9 k
6. Use of a 0.1 F bypass capacitor connected between pins 1 and 3, & 5 and 7 adjacent to the device is recommended.
7. Common mode transient immunity in a Logic High level is the maximum tolerable (positive) dV
8. The frequency at which the ac output voltage of 3 dB below the low frequency asymptote.
9. Device considered a two-terminal device. Pins 1, 2, 3, and 4 shorted together and Pins 5, 6, 7, and 8 shorted together.
Side 1 – Side 2
Momentary Withstand
Voltage*
Side 1 – Side 2
Resistance
Side 1 – Side 2
Capacitance
continuous voltage rating. For the continuous voltage rating refer to the VDE 0884 Insulation Characteristics Table (if applicable),
your equipment level safety specification or HP Application Note 1074 entitled “Optocoupler Input–Output Endurance Voltage,”
publication number 5963-2203E.
to set the proper drive currents.
times 100%.
V
Common mode transient immunity in a Logic Low level is the maximum tolerable (negative) dV
V
(leakage detection current limit, I
CM,
CM,
Parameter
to assure that the output will remain in a Logic High state (i.e., V
to assure that the output will remain in a Logic Low state (i.e., V
CC
common configuration, Input LED current is a function of the V
load represents 1 TTL load of 1.6 mA and 5.6 k pull-up resistor.
A
= 25˚C.
Sym. Min. Typ. Max. Units
V
R
C
ISO
1–2
1–2
I–O
2500
< 5 A).
0.25
10
12
Vrms RH < 50%, t = 1 min.,
pF
O
O
< 0.8 V).
T
RH
V
f = 1 MHz
> 2.0 V).
A
I–O
CC
= 25 C
= 500 Vdc
supply voltage. See application information section
45%, t = 5
Test Conditions
O
, to the forward LED input current I
7
S
,
CM
CM
/dt of the common mode pulse,
/dt of the common mode pulse,
Fig. Note
F
9,10
,
9
9