mic3003gfltr Micrel Semiconductor, mic3003gfltr Datasheet - Page 54

no-image

mic3003gfltr

Manufacturer Part Number
mic3003gfltr
Description
Fom Management Ic With Internal Calibration
Manufacturer
Micrel Semiconductor
Datasheet
Micrel, Inc.
July 2010
Default value
Serial address
Byte address
This register provides for control of the nominal APC setpoint and management of interrupts by the end-user. APCSEL[1:0]
select which of the APC setpoint registers, APCSET0, APCSET1, or APCSET2 are used as the nominal automatic power
control setpoint. Similarly, MODSEL[1:0] select which of MODSET0, MODSET1, or MODSET2 are used to select the
modulation level of the laser.
IE must be set for any host interrupts to occur via the /INT pin. If IE is set while /INT is asserted, /INT will be de-asserted
immediately.
PORS is always set high by any power-on reset event. If PORM is high, the power-on event will also generate a host interrupt.
PORS will be cleared to zero and the interrupt output de-asserted when USRCTL is read by the host.
If PORM is set following the setting of PORS, PORS will remain set, and /INT will be asserted immediately. /INT will not be de-
asserted until USRCTL is read by the host.
PORM, IE, APCSEL, and MODSEL are non-volatile and will be maintained through power and reset cycles.
Default Value
Serial address
Byte address
read/write
D[3:2]
D[1:0]
read-only
Reserved
reserved
D[7]
D[6]
D[5]
D[4]
D[7]
D[7]
Bit(s)
MODSEL
APCSEL
PORM
PORS
IE
read/write
read-only
reserved
PORM
D[6]
D[6]
Function
Reserved
Power-on interrupt mask
Power-on interrupt flag
Global interrupt enable
Selects APC setpoint register
Selects Modulation setpoint register
read/write
read-only
reserved
PORS
D[5]
D[5]
User Control Register (USRCTL)
0010 0000 b = 20 h
A2 h
254 = FE h
A2 h
255 = FF h
read/write
read-only
reserved
D[4]
D[4]
IE
RESETOUT
Operation
Always write as zero; reads undefined.
1 = POR interrupts mask enabled
0 = POR interrupts mask disabled
1 = POR interrupt occurred
0 = No POR interrupt
1 = Host interrupts are enabled
0 = Host interrupts are disabled
00 = APCSET0
01 = APCSET1
10 = APCSET2
11 = Reserved
00 = MODSET0
01 = MODSET1
10 = MODSET2
11 = Reserved
read/write
read-only
54
reserved
APCSEL
D[3]
D[3]
0000 0000 b = 00 h
RESETOUT
read/write
read/write
APCSEL
D[2]
D[2]
hbwhelp@micrel.com
RESETOUT
read/write
read/write
APCSEL
D[1]
D[1]
RESETOUT
or (408) 955-1690
read/write
read/write
M9999-072910-A
MODSEL
MIC3003GFL
D[0]
D[0]

Related parts for mic3003gfltr