at94k05al-25aqi ATMEL Corporation, at94k05al-25aqi Datasheet - Page 68
at94k05al-25aqi
Manufacturer Part Number
at94k05al-25aqi
Description
5k - 40k Gates Of At40k Fpga With 8-bit Microcontroller, Up To 36k Bytes Of Sram And On-chip Jtag Ice
Manufacturer
ATMEL Corporation
Datasheet
1.AT94K05AL-25AQI.pdf
(192 pages)
Available stocks
Company
Part Number
Manufacturer
Quantity
Price
- Current page: 68 of 192
- Download datasheet (3Mb)
JTAG Interface and
On-chip Debug
System
Features
Overview
The Test Access
Port – TAP
68
AT94K Series FPSLIC
•
•
•
•
•
The AVR IEEE std. 1149.1 compliant JTAG interface is used for on-chip debugging.
The On-Chip Debug support is considered being private JTAG instructions, and distributed
within ATMEL and to selected third-party vendors only.
Figure 39 shows a block diagram of the JTAG interface and the On-Chip Debug system. The
TAP Controller is a state machine controlled by the TCK and TMS signals. The TAP Controller
selects either the JTAG Instruction Register or one of several Data Registers as the scan
chain (shift register) between the TDI - input and TDO - output. The Instruction Register holds
JTAG instructions controlling the behavior of a Data Register.
Of the Data Registers, the ID-Register, Bypass Register, and the AVR I/O Boundary-Scan
Chain are used for board-level testing. The Internal Scan Chain and Break-Point Scan Chain
are used for On-Chip debugging only.
The JTAG interface is accessed through four of the AVR’s pins. In JTAG terminology, these
pins constitute the Test Access Port - TAP. These pins are:
•
•
•
•
The IEEE std. 1149.1 also specifies an optional TAP signal; TRST - Test ReSeT - which is not
provided.
When the JTAGEN bit is unprogrammed, these four TAP pins revert to normal operation.
When programmed, the input TAP signals are internally pulled High and the JTAG is enabled
for Boundary-Scan. System Designer sets this bit by default.
For the On-Chip Debug system, in addition the RESET pin is monitored by the debugger to be
able to detect external reset sources. The debugger can also pull the RESET pin Low to reset
the whole system, assuming only open collectors on reset line are used in the application.
JTAG (IEEE std. 1149.1 Compliant) Interface
AVR I/O Boundary-scan Capabilities According to the JTAG Standard
Debugger Access to:
Extensive On-chip Debug Support for Break Conditions, Including
On-chip Debugging Supported by AVR Studio version 4 or above
– All Internal Peripheral Units
– AVR Program and Data SRAM
– The Internal Register File
– Program Counter/Instruction
– FPGA/AVR Interface
– Break on Change of Program Memory Flow
– Single Step Break
– Program Memory Breakpoints on Single Address or Address Range
– Data Memory Breakpoints on Single Address or Address Range
– FPGA Hardware Break
– Frame Memory Breakpoint on Single Address
TMS: Test Mode Select. This pin is used for navigating through the TAP-controller state
machine.
TCK: Test Clock. JTAG operation is synchronous to TCK
TDI: Test Data In. Serial input data to be shifted in to the Instruction Register or Data
Register (Scan Chains)
TDO: Test Data Out. Serial output data from Instruction register or Data Register
Rev. 1138F–FPSLI–06/02
Related parts for at94k05al-25aqi
Image
Part Number
Description
Manufacturer
Datasheet
Request
R
Part Number:
Description:
Fpslic Devices Combine 5K Gates of Atmel's Patented AT40K Fpga Architecture, a 20 Mips Avr 8-bit Risc Microprocessor Core, Numerous Fixed Microcontroller Peripheries And up to 36K Bytes of Program And Data SRAM.
Manufacturer:
ATMEL Corporation
Datasheet:
Part Number:
Description:
At94k05al 5k - 40k Gates Of At40k Fpga With 8-bit Microcontroller, Up To 36k Bytes Of Sram And On-chip Jtag Ice
Manufacturer:
ATMEL Corporation
Datasheet:
Part Number:
Description:
INTERVAL AND WIPE/WASH WIPER CONTROL IC WITH DELAY
Manufacturer:
ATMEL Corporation
Datasheet:
Part Number:
Description:
Low-Voltage Voice-Switched IC for Hands-Free Operation
Manufacturer:
ATMEL Corporation
Datasheet:
Part Number:
Description:
MONOLITHIC INTEGRATED FEATUREPHONE CIRCUIT
Manufacturer:
ATMEL Corporation
Datasheet:
Part Number:
Description:
AM-FM Receiver IC U4255BM-M
Manufacturer:
ATMEL Corporation
Datasheet:
Part Number:
Description:
Monolithic Integrated Feature Phone Circuit
Manufacturer:
ATMEL Corporation
Datasheet:
Part Number:
Description:
Multistandard Video-IF and Quasi Parallel Sound Processing
Manufacturer:
ATMEL Corporation
Datasheet:
Part Number:
Description:
High-performance EE PLD
Manufacturer:
ATMEL Corporation
Datasheet:
Part Number:
Description:
8-bit Flash Microcontroller
Manufacturer:
ATMEL Corporation
Datasheet:
Part Number:
Description:
2-Wire Serial EEPROM
Manufacturer:
ATMEL Corporation
Datasheet: