tsc2024 Traco Power, tsc2024 Datasheet - Page 8

• Manufacturer Part Number: tsc2024
• Description: Dc/dc Converter
• Manufacturer: Traco Power

All specifications valid at nominal input voltage, full load and +25°C after warm-up time unless otherwise stated.
www.tracopower.com
General Specifications
Safety standards
Electromagnetic compatibility (EMC), Emission
External programming
Extended temperature range
Reliability (MIL-HDBK-217 E)
Electromagnetic compatibility (EMC), Immunity
Connection
Power fail
Relay output
External On/OFF
Wall mounting
Isolation resistance
DC- ok
System reset
Current sharing
Decoupling diode
Inrush current limiting
Mechanical strength
Control Options
I/O Options
Alarm Options
Mechanical Options
– Electrical fast transients / burst immunity
– Conducted RI suppression on input
Option “p”
Option “d”
Option “r”
Option “h”
Option “y”
Option “cs”
Option “dd”
Option “i”
Option “w”
Option “ms”
Option “c”
Option “e”
Further options and combinations on request!
– Input/Output (500VDC)
–Surge immunity
Signal if input voltage drops below the specified limit.
Signal output is NPN open collector, activated in ok-status
Signal if output voltage drops below the specified limit
Signal output is NPN open collector, activated in ok-status
Relay instead of logical output for alarm signals.
(in combination with option “p” and “d”)
Connection to negative input line inactivates the unit
Reset input specified for VME systems
or an external voltage of 0VDC to 10VDC. Details need to be
specified.
Provides balanced load for units in parallel operation.
Controlled over interconnecting wire.
For redundant operation. Internal fault of one unit does not affect
other units in a parallel circuit .
A thermistor in series to the input lines reduces its resistance
when it gets warm.
This option includes screw terminal block for connection
Rugged construction for harsh environment.
The unit is designed and tested for operation at an ambient
temperature range of –40...+75°C
External programming of the output voltage by a potentiometer
Module is screwed on a mounting plate for install in a cabinet
> 10 M Ohm
> 100’000 h @ 40°C
IEC/EN 60950
EN 55022, class A (class B on request)
IEC/EN 61000–4–4, 2kV
IEC/EN 61000–4–5, 2kV
H15 male connector (DIN 41612)
(screw terminal for output current >50A)
DC/DC Converter
TSC Series 50 – 2500 Watt
Page 8