ir3088a International Rectifier Corp., ir3088a Datasheet - Page 32

• Manufacturer Part Number: ir3088a
• Description: Xphase Ic With Fault And Overtemp Detect
• Manufacturer: International Rectifier Corp.

Stencil Design
• The stencil apertures for the lead lands should be approximately 80% of the area of the lead lands.
• The stencil lead land apertures should therefore be shortened in length by 80% and centered on the lead
• The land pad aperture should be striped with 0.25mm wide openings and spaces to deposit approximately
• The maximum length and width of the land pad stencil aperture should be equal to the solder resist opening
Page 32 of 33
Reducing the amount of solder deposited will minimize the occurrence of lead shorts. Since for 0.5mm pitch
devices the leads are only 0.25mm wide, the stencil apertures should not be made narrower; openings in
stencils < 0.25mm wide are difficult to maintain repeatable solder release.
land.
50% area of solder on the center pad. If too much solder is deposited on the center pad the part will float
and the lead lands will be open.
minus an annular 0.2mm pull back to decrease the incidence of shorting the center land to the lead lands
when the part is pushed into the solder paste.
IR3088A
1/15/
05