sm145g0 NEC Tokin, sm145g0 Datasheet - Page 3

• Manufacturer Part Number: sm145g0
• Description: Fusible Alloy Thermal Sensitive Type Amperes Va.c. Amperes Vd.c. Rated Current
• Manufacturer: NEC Tokin

Rated Functioning Temperature
Rated functioning temperature is the operating temperature of the thermal cutoff, measured using the method
specified in the safety standard. In Electrical Appliance and Material Control Law of Japan, case operation
should be within the specified operating temperature range of
standard (such as UL, CSA, VDE, BEAB), it is called the rated functioning temperature, and should operate
within the prescribed temperature range of +0/–10 ˚C.
It is represented by the symbol T
standards.
In SEFUSE, a temperature that complies with both standards is set as the rated functioning temperature, and
is indicated on the body of the thermal cutoff.
Operating Temperature
Operating temperature is the operating temperature range when the thermal cutoff is made to operate inside
a constant temperature oven whose temperature is raised at the rate of 1 ˚C/min. while a detection current of
100 mA or lower is applied.
The operating temperature is a standard set by NEC and is not specified by a safety standard.
T
Holding temperature is the maximum temperature at which, when applying a rated current to the thermal
cutoff, the state of conductivity is not changed during 168 hours.
It is represented by the symbol T
standards.
T
Maximum temperature limit is the maximum temperature for which conductivity does not occur again after
thermal cutoffs operation.
It is represented by the symbol T
Rated Current
Maximum alternating current that can pass through the thermal cutoff and that the thermal cutoffs can cut off
the circuit in safety and reliability.
Rated Voltage
Maximum circuit voltage that the thermal cutoffs can cut off the circuit in safety and reliability.
H
M
, Th. Tc (Holding Temperature)
, Tm (Maximum Temperature Limit)
H
M
F
in the UL standard, Th in the CSA standard, and Tc in the VDE and BEAB
in the UL standard and by Tm in the CSA, VDE and BEAB standards.
in the UL standard, and by the symbol Tf in the CSA, VDE and BEAB
Definition of Terms
7 ˚C. In standards that comply with the IEC
SM/G SERIES
3