ds1834aut-r Maxim Integrated Products, Inc., ds1834aut-r Datasheet - Page 4

• Manufacturer Part Number: ds1834aut-r
• Description: Ds1834, Ds1834a, Ds1834d Dual Econoreset With Pushbutton
• Manufacturer: Maxim Integrated Products, Inc.

DS1834/A/D
OUTPUT VALID CONDITIONS
All versions of the DS1834 can maintain valid outputs as long as one input remains above 1.2 volts.
However, the
outputs on the DS1834 use a push-pull output structure which can maintain a valid
RST
output below 1.2 volts. To sink current below 1.2 volts a resistor can be connected from
to GND
RST
(see Figure 5). This arrangement will maintain a valid value on the
outputs even if all inputs are at 0
RST
volts. During both power-up and power-down this arrangement will draw current when
is in the high
RST
state. A value of about 100 k =should be adequate to maintain a valid condition.
The DS1834A requires pull-up resistors on the outputs to maintain a valid output. The value of the
resistors is not critical in most cases but must be set low enough to pull the output to a high state. A
common value used is 10 k s (see Figure 6 and Figure 7).
APPLICATION DIAGRAM:
VALID TO 0 VOLTS V
ON THE DS1834 Figure 5
RST
CC
APPLICATION DIAGRAM: DS1834A NMOS OUTPUTS Figure 6
Note: If outputs are pulled-up to different voltages the outputs can not be connected to form a wired
"AND".
APPLICATION DIAGRAM: DS1834A WIRED "AND" OUTPUT Figure 7
4 of 7