a2500r24c Anaren Microwave, a2500r24c Datasheet - Page 24

• Manufacturer Part Number: a2500r24c
• Description: Anaren Integrated Radio
• Manufacturer: Anaren Microwave

Page 24 of 26
Noise on the power supply line reduces the sensitivity of a receiver and modulates onto a
transmitters signal, both of which causes a degradation of link quality and hence a reduction in
range.
The A2500R24C and A2500R24A radio modules each have an integral ferrite bead in the
supply line from pin 18 (Vdd) and decoupling capacitance to reduce any noise on the incoming
power supply line. This arrangement will eliminate most supply voltage noise. In particular noisy
environments (switching regulators, motor controls, etc.), it may be necessary to add additional
noise reduction means.
Pin 7 (Vdcoup1) is connected to the modules internal supply line after the ferrite bead and
decoupling capacitors and can be used to probe the noise at module level. The noise level
measured on pin 7 should not exceed 120mVpp when in transmit or receive mode, it may
however exceed this value when setting up or accessing data to/from the FIFO’s while not
actively transmitting or receiving.
If the level measured is exceeding the above limit, steps should be taken to ensure maximum
range, including:
3.5.
•
•
•
Adding decoupling capacitance to pin 7 (Vdcoup1).
Adding additional filtering in the supply line.
Adding an LDO in the supply line (the TPS731xx low Dropout Regulator from TI is
recommended).
Power Supply Considerations
A2500R24x – Users Manual
Release Date 01/10/11