spp-8f-sr-edfm Source Photonics, Inc., spp-8f-sr-edfm Datasheet - Page 7

• Manufacturer Part Number: spp-8f-sr-edfm
• Description: Support 2.125/4.25/8.5g Fiber Channel Applications
• Manufacturer: Source Photonics, Inc.

Order Information
Table 8 – Order Information
2.
3.
4.
5.
Mechanical Diagram
SPP-8F-SR-EDFM
TX_FAULT is an open collector/drain output. The pins must be pulled up with 4.7kΩ-10kΩ resistor.
A high output indicates a transmitter fault. A low output indicates normal operation. In the low state,
the output is pulled to < 0.8V.
The pin is pulled up to V
laser output is disabled. When TX_Disable is < 0.8V, laser is enabled.
The pins must be pulled up with 4.7K-10Kohms to a voltage between 3.14V and 3.46V on host board.
The pins are pulled low to V
Part No.
Units in mm(inch)
Preliminary Datasheet Preliminary Datasheet
8G Fiber Channel
CC
Application
T with a 4.7K-10KΩ resistor in the module. When TX_Disable is > 2.0V,
CC
Figure 4, Mechanical Diagram of SFP+
T with a >30kΩ resistor in the module.
2.125G~8.5G
Data Rate
850nm VCSEL
Laser Source
SPP-8F-SR-EDFM
DS-6399 Rev 01 2010-12-28
Preliminary Datasheet
Fiber Type
MMF