LTC3212 Linear Technology, LTC3212 Datasheet - Page 10

• Manufacturer Part Number: LTC3212
• Description: RGB LED Driver and Charge Pump
• Manufacturer: Linear Technology

LTC3212
applicaTions inForMaTion
Power Efficiency
To calculate the power efficiency (η) of an LED driver chip,
the LED power should be compared to the input power.
The difference between these two numbers represents
lost power whether it is in the charge pump or the cur-
rent sources. Stated mathematically, the power efficiency
is given by:
The efficiency of the LTC3212 depends upon the mode in
which it is operating. Recall that the LTC3212 operates
as a pass switch, connecting V
is detected at an I
timum efficiency available for a given input voltage and
LED forward voltage. When it is operating as a switch, the
efficiency is approximated by:
since the input current will be very close to the sum of
the LED currents.
At moderate to high output power, the quiescent current
of the LTC3212 is negligible and the expression above is
valid.
0
η =
η =
P
P
P
P
LED
LED
IN
IN
=
V
V
BAT
LED
LED
•
•
I
I
pin. This feature provides the op-
LED
BAT
=
V
V
LED
BAT
IN
to CPO, until dropout
Once dropout is detected at any LED pin, the LTC3212
enables the charge pump in 2x mode.
In 2x boost mode, the efficiency is similar to that of a
linear regulator with an effective input voltage of 2 times
the actual input voltage. In an ideal 2x charge pump, the
power efficiency would be given by:
In some applications it may be possible to increase the
efficiency of the LTC3212. If any of the LED’s maximum
forward voltage is less than the minimum V
age minus I
not needed to drive that LED. This is often the case with
the red LED due to its lower forward voltage. Its anode
may be connected directly to V
pump’s losses in 2x mode.
Thermal Management
If the junction temperature increases above approximately
140°C the thermal shutdown circuitry will automatically
deactivate the output current sources and charge pump.
To reduce maximum junction temperature, a good thermal
connection to the PC board is recommended. Connecting
the Exposed Pad to a ground plane and maintaining a solid
ground plane under the device will reduce the thermal
resistance of the package and PC board considerably.
η
IDEAL
=
LED
P
P
LED
IN
dropout voltage then the charge pump is
=
V
BAT
V
LED
• •
2
•
I
LED
I
LED
IN
, bypassing the charge
www.DataSheet4U.com
=
2
V
•
LED
V
B B AT
IN
supply volt-
3212fb