ALD12 Dilor, ALD12 Datasheet - Page 2

• Manufacturer Part Number: ALD12
• Description: Dimmer Enclosures
• Manufacturer: Dilor

ALD Dimmer Enclosures -Installation
tel: [phone] / fax: [phone]
Dimming Panels and Dimmers 1/04
top left of Panel ONLY
Breakers
Input Feeders
Access
Input
Location
Air Exhaust Vents
Air Intake Vents
ALD Dimmer Panel
(cover installed)
Breakers
Access
Output
Output
Branch
Circuiting
Location
top right
and
right side
of
Panel
ONLY
Input
Control
Circuit
Location
bottom
right side
of Panel
ONLY
page 2
INSTALLATION
SITE REQUIREMENTS
The Dimmer Panel must be mounted in the orientation shown
in the illustration at left.
Note the location of the input feeder(s), output branch
circuiting and input control circuits from the wall stations.
(Consult 'Dimensions -ALD6 Enclosure' and 'Dimensions -
ALD12 Enclosure' on the following 2 pages to assist with
correct location of conduits.)
Install the mounting fasteners:
Install conduit and pull wires.
IThe installer is responsible for wiring and connecting the
input supply and output circuits to the fixture and the wires
from the control stations to the panel.
The panel location must have ventilation.
The panel location must be free of excess dust.
The ambient temperature must be between 30
110
The mounting wall must be vibration-free.
The atmosphere in the room must be non-corrosive.
The humidity in the room must be non-condensing.
-Mounting fasteners are not supplied.
-Use a fastener that has a 1/4" shank.
-Install upper 2 fasteners first, use key holes in cabinet
flange to hang. Tighten fasteners, then install lower 2
fasteners.
O
F (40
O
C).
www.DouglasLightingControls.com
lighting controls
O
F (0
O
C) and