ATP0574-1 AZ Displays, ATP0574-1 Datasheet - Page 6

• Manufacturer Part Number: ATP0574-1
• Description: SPECIFICATIONS FOR STANDARD RESISITIVE TOUCH PANEL
• Manufacturer: AZ Displays

www.DataSheet4U.com
Location
1.
2.
3.
4.
AZ DISPLAYS, INC.
(Drawing) with conductive connector and glass
side down. See page 1 for detail of connector exit
side which is left.
•
The details below indicate the recommended mounting structure for panel and enclosure. The enclosure
support to fix the touch panel must be over 1.0mm I width and must be outside the view (Transparent area).
Also ensure that the enclosure does not cause miss input by touching the view area.
The following diagram shows that the enclosure edge must be between the View area and the guaranteed
active area. Ensure space is allocated for the diodes, and we recommend that the material to fix the panel
and enclosure is elastic. Special design would be required to stop water ingress. The corners of the touch
panel are conductive so do not touch any metal parts after mounting.
•
6.0 CONNECTION AND MOUNTING
0.3 to 0.1 mm
7.0 PANEL THICKNESS (typical)
Detect
Bottom
Left
Top
Right
Shock absorber to protect
the panel (eg rubber)
Stiffener Board
Conductive Face
View Area
Transparent Area
Input Area
Input Panel
5.1
Anit-input Area
Stiffener board 10.2
Circuit Board
LCD
0.8 mm min.
Thickness of Glass 1.1mm
Upper Case
Wiring Area
(Mating connector type SFW4R-1ST: for FPC)
Connector
Top View (Picture, with conductive
side down)
Shock absorber
for protection
Cut-out / avoidance of
550 surface mount diodes
ATP0574-1
Page 6 of 7