RFP-100-50TW Anaren Microwave, RFP-100-50TW Datasheet - Page 2

• Manufacturer Part Number: RFP-100-50TW
• Description: Flanged Terminations
• Manufacturer: Anaren Microwave

4.5.46
www.DataSheet4U.com
Typical Performance
Power Derating
Model RFP-100-50TW
100
75
50
25
0
25
50
CASE TEMPERATURE — C
75
Sales Desk Europe: Voice: ([phone] Fax: [phone]
100
Sales Desk USA: Voice: [phone] Fax: [phone]
125
150
Suggested Mounting Procedures
1. Make sure that the devices are mounted on flat surfaces
2. Drill & tap the heatsink for the appropriate thread size to be
3. Coat heatsink with a minimum amount of high quality
4. Position device on mounting surface and secure using sock-
5. Solder leads in place using an SN63 type solder with a
.025
(2 PLACES)
(.001” under the device) to optimize the heat transfer.
used.
silicone grease (.001” max. thickness).
et head screws, flat & split washers. Torque screws to the
appropriate value. Make sure that the device is flat against
the heatsink. (Care should be taken to avoid upward pres-
sure of the leads towards the lid).
controlled temperature iron (210°C).
BOARD LOWER
THAN LEAD.
SUGGESTED STRESS RELIEF METHODS
MIN.
SCALE:
BOARD EVEN
WITH LEAD.
BOARD LOWER
THAN LEAD.
NOT RECOMMENDED APPLICATION
SCALE:
BOARD HIGHER
THAN LEAD.