AN2777 Freescale Semiconductor / Motorola, AN2777 Datasheet - Page 4

• Manufacturer Part Number: AN2777
• Description: Tango3 Monitor for the MC9S08RG60 MCU
• Manufacturer: Freescale Semiconductor / Motorola

Requirements
Requirements
To use the software, you must have the following hardware and software.
Full source code for the Tango3 monitor is available; this allows the monitor to be extended or modified,
if required.
Programming Tango3 Monitor into the MC9S08RG60 MCU Using MC9S08RG60 Serial
Monitor
The Tango3 monitor program must be programmed into the FLASH memory of the MC9S08RG60 Demo
Board before it can be used. There are several programming tools available for the HC(S)08 MCU families
that can be used for this purpose. This application note describes how to program the MC9S08RG60
using a free evaluation copy of the CodeWarrior development environment and the MC9S08RG60 Demo
Board’s built-in serial monitor.
To do this:
4
1. Install power select (PWR_SEL) jumpers 1 and 2 on the MC9S08RG60 Demo Board. Both jumpers
2. Install all USER jumpers.
3. Connect the serial port connector on the MC9S08RG60 Demo Board to a PC comm. port using a
4. Connect a 9V power supply or battery tothe power connector on the MC9S08RG60 Demo Board.
5. Install CodeWarrior.
6. Unzip file Tango3RG60MonSource.zip (contained within AN2777SW.zip). This unzips a
•
•
•
•
•
MC9S08RG60 Demo Board (part number: DEMO9S08RG60)
Tango RF module (part number: MC33493MOD315 or MC33493MOD434 — others may be
available)
MetroWerks CodeWarrior version 3.0 or later
'AN2777SW.zip', which contains the software files
A PC running Hyperterminal, or any other terminal program
must be installed.
9-pin straight-through serial cable.
CodeWarrior project containing the programming file for the monitor.
You must have a copy of the CodeWarrior development tool for HC(S)08
installed. A copy of CodeWarrior is supplied with the MC9S08RG60 Demo
Board. Please follow the instructions supplied with the demo board.
This project does not contain any source code. If you wish to read or modify
the Tango3 monitor source code, you should unzip file
Tango3RG60MonProg.zip, contained in AN2777SW.zip. To modify this
Tango3 Monitor for the MC9S08RG60 MCU, Rev. 0
NOTE
NOTE
Freescale Semiconductor