AN1102F Stanley Electric Co., Ltd., AN1102F Datasheet - Page 8

• Manufacturer Part Number: AN1102F
• Description: LED, SMT Shape-Infrared Led, Reel
• Manufacturer: Stanley Electric Co., Ltd.

2004.11.17
Reflow Soldering Conditions
TTW (Through The Wave) soldering Conditions
Manual Soldering Conditions
1) The above profile temperature gives the maximum temperature of the LED resin surface.
2) Total times of reflow soldering process shall be no more than 2 times.
3) Temperature fluctuation to the LED during the pre-heating process shall be minimized.
1) The dip soldering process shall be 2 times maximum.
2) The product shall be cooled to normal temperature before the second dipping process.
Please set the temperature so as to avoid exceeding this range.
When the second reflow soldering process is performed, intervals between the first
and second reflow should be short as possible (while allowing some time for the
component to return to normal temperature after the first reflow) in order to prevent the
LED from absorbing moisture.
Pre-heating
Solder Bath Temp.
Dipping Time
Iron tip temp.
Soldering time and frequency
120℃∼150 ℃
265 ℃
350 ℃
60 s ∼120 s
5 s
3 s
1 time
(MAX.)
(MAX.)
(MAX.)
(MAX.)
(MAX.) (30 W Max.)
(MAX.)
(MAX.)
AN1102F
Surface Mount IRED/Right Angle Type
Page 8