USB2512I SMSC Corporation, USB2512I Datasheet - Page 13

• Manufacturer Part Number: USB2512I
• Description: Industrial Temperature Rated USB 2.0 High-Speed 2-Port Hub Controller
• Manufacturer: SMSC Corporation

Industrial Temperature Rated USB 2.0 High-Speed 2-Port Hub Controller
Datasheet
Chapter 4 Configuration Options
SMSC USB2512i
4.1
4.1.1
4.1.1.1
4.1.2
4.2
4.2.1
ADDR
REG
00h
01h
02h
SMSC’s USB 2.0 2-Port Hub is fully specification compliant to the Universal Serial Bus Specification
Revision 2.0 April 27,2000 (12/7/2000 and 5/28/2002 Errata). Please reference Chapter 10 (Hub
Specification) for general details regarding Hub operation and functionality.
The 2-Port Hub provides 1 Transaction Translator (TT) that is shared by both downstream ports
(defined as Single-TT configuration), The TT contains 4 non-periodic buffers.
Hub Configuration Options
The SMSC Hub supports a large number of features (some are mutually exclusive), and must be
configured in order to correctly function when attached to a USB host controller. There are three
principal ways to configure the hub: SMBus, EEPROM, or by internal default settings (with or without
pin strapping option over-rides). In all cases, the configuration method will be determined by the
CFG_SEL1 and CFG_SEL0 pins immediately after RESET_N negation.
Power Switching Polarity
The hub only supports “active high” port power controllers.
VBus Detect
According to Section 7.2.1 of the USB 2.0 Specification, a downstream port can never provide power
to its D+ or D- pull-up resistors unless the upstream port’s VBUS is in the asserted (powered) state.
The VBUS_DET pin on the Hub monitors the state of the upstream VBUS signal and will not pull-up
the D+ resistor if VBUS is not active. If VBUS goes from an active to an inactive state (Not Powered),
Hub will remove power from the D+ pull-up resistor within 10 seconds.
The SMSC Hub can be configured via a 2-wire (I2C) EEPROM (256x8). (Please see
specific details on how to enable configuration via an I2C EEPROM).
The Internal state-machine will (when configured for EEPROM support) read the external EEPROM for
configuration data. The hub will then “attach” to the upstream USB host.
Note: The Hub does not have the capacity to write, or “Program,” an external EEPROM. The Hub only
has the capability to read external EEPROMs. The external eeprom will be read (even if it is blank or
non-populated), and the hub will be “configured” with the values that are read.
Please see Internal Register Set (Common to EEPROM and SMBus) for a list of data fields available.
Internal Register Set (Common to EEPROM and SMBus)
2-Port Hub
EEPROM Interface
R/W
R/W
R/W
R/W
Table 4.1 Internal Default, EEPROM and SMBus Register Memory Map
REGISTER NAME
VID MSB
VID LSB
PID LSB
DATASHEET
13
ABBR
VIDM
VIDL
PIDL
DEFAULT ROM
INTERNAL
04h
24h
12h
Revision 1.92 (11-28-07)
EEPROM POR
SMBUS AND
VALUES
Table 3.1
0x00
0x00
0x00
for