MPS-501G World Products, Inc., MPS-501G Datasheet - Page 5

• Manufacturer Part Number: MPS-501G
• Description: Medical Pres Sure Sensor
• Manufacturer: World Products, Inc.

NOTES
1. Pressure media is non-corrosive gas. Type of pressure application is gauge, with bottom pressure application.
2. Positive pressure is applied at port.
3. Soldering process recommendations: due to its small size the thermal resistance of the pressure sensor package
4. PCB post cleaning: as the pressure sensor chip is exposed to atmosphere do not allow cleaning fluid to enter
5. Environment: consult with MemsTech before using or storing the pressure sensor chip in a place exposed to
6. For any additional and or specific test data or information please contact MemsTech.
7. Handling Recommendations:
260°C 500° F , 5 sec soldering iron: 260 to 300°C 500 to 572° F (30W) within 5 sec. When using a non-corrosive
resin type of flux ensure that pressure sensor element is not exposed to the flux, and the flux is not allowed to
enter inside the package pressure ports or atmospheric ports.
inside the port and avoid ultrasonic cleaning as this may cause breaks or disconnections in the wiring.
adversely affect the performance of the pressure sensor chip.
corrosive gases (including gases given off by organic solvents, sulfites, hydrogen sulfides, etc.) which will
type is low. Therefore, take appropriate steps to minimize the effects of external heat. Dip soldering bath: Max.
a. Using a pressure range other than what is specified or using other non-industry standard mounting conditions
b. Air can be used directly as a pressure medium. Consult with MemsTech before using a corrosive media
c. The pressure sensor chip is positioned inside the pressure inlet. Do not introduce any invasive instruments
d. Use an operating pressure which is within the rated pressure range. Using a pressure beyond this range
e. As the pressure sensor chip is not media isolated, consult with MemsTech if it is to be used in a location
f. Avoid using the pressure sensor in environment’s where condensation may form, as this may have an effect
g. The out put of the pressure sensor element may be influenced when exposed to light. In case of pressure being
h. Avoid using the pressure sensor product where it will be exposed to ultrasonic or other high-frequency vibration
i. Since Electro Static Discharge (ESD) can damage the pressure sensor product, ensure proper handling
or methods may result in the product non-conformance to specifications.
(including gases given off by organic solvents, sulfites or hydrogen sulfides, etc.) as the pressure medium.
or other fore pin mates inside the ports or through the pressure inlet as this may damage the sensor or block
the inlet. Avoid use when the atmospheric pressure inlet is obstructed or covered.
where it may be introduced to moisture, including post cleaning processes with water, etc.
upon the electrical output functions of the sensor and cause it to fluctuate under varying environmental conditions.
applied by means of a transparent tube take appropriate measures to prevent the pressure sensor element from
being directly exposure to light.
conditions, and ensure that work stations and operators are properly grounded.
Medical Pressure Sensor
may cause damage to the sensor.
MPS-501G
1907 Westlands Centre, 20 Westlands Road, Quarry Bay, Hong Kong
Tel : [phone]
Email : [e-mail]
Website : www.jlworld.com
Fax : [phone]
Document #: PPDS-SMPS-007-07U-PP400 Rev B
060118-A2
Page 5 of 6