ST-10M2 ELECTRONIC AUTOMATION, ST-10M2 Datasheet - Page 8
ST-10M2
Manufacturer Part Number
ST-10M2
Description
Sequential Timers
Manufacturer
ELECTRONIC AUTOMATION
Datasheet
1.ST-10M2.pdf
(8 pages)
www.DataSheet.co.kr
P r o g r a m m i n g t h e T i m e r
I n i t i a t i n g a S e q u e n c e
T i m e r C a s c a d i n g
Sequential Timer
Keep the PROG/RUN slide switch in the “PROG” position.
Apply rated voltage across A1 and A2.
By using the “SEQUENCE” button, select the required output, to program the timer.
By using the “ON / OFF” button, select the “ON “and “OFF” time for particular output.
By using the “RANGE “button, select the desired time range (sec/sec or min/sec or
Set the required time by using “ADV” button.
After programming the timer, keep the ”RUN/PROG” slide switch in “RUN“ position and the
By shorting the S1 and S2 terminals on the front panel for a minimum period of 150
The sequence starts with closure of “RLY0/OP1”as the case may be.
S1 and S2 can be kept permanently shorted to start the sequence when in HOLD mode.
In case of restart mode start signal is required every time a sequence has to be initiated.
Short C1 and C2 of all the timers to be cascaded.
Connect O1 and O2 of the first timer to S1 and S2 respectively of the second timer and so
hrs/min) as per requirement.
unit is ready for operation.
milliseconds, the timing is initiated.
on. (O1S1 – O2S2 and so on….)
Quick Reference Guide
Datasheet pdf - http://www.DataSheet4U.net/