SC2655 Semtech Corporation, SC2655 Datasheet - Page 20
![no-image](/images/manufacturer_photos/0/5/596/semtech_corporation_sml.jpg)
SC2655
Manufacturer Part Number
SC2655
Description
Programmable Synchronous DC/DC Hysteretic Controller
Manufacturer
Semtech Corporation
Datasheet
1.SC2655.pdf
(20 pages)
1. Locate R8 and C2 close to pins 6 and 7.
2. Locate C1 close to pins 5 and 7.
3. Components connected to IOUT, DROOP, OCP, VHYST,
VREFB, VSENSE, and SOFTST should be referenced to
AGND.
4. The bypass capacitors C5 and C10 should be placed
close to the IC and referenced to DRVGND.
5. Locate bootstrap capacitor C8 close to the IC.
6. Place bypass capacitor close to Drain of the top FET and
Source of the bottom FET to be effective.
7. Route HISENSE and LOSENSE close to each other to
minimize induced differential mode noise.
8. Bypass a high frequency disturbance with ceramic
capacitor at the point where HISENSE is connected to Vin.
9. Input bulk capacitors should placed as close as possible
to the power FETs because of the very high ripple current
flow in this pass.
POWER MANAGEMENT
Layout Guidelines (See pg. 1)
Outline Drawing - SO-28
Contact Information
2003 Semtech Corp.
www.DataSheet4U.com
Phone: (805)498-2111 FAX (805)498-3804
Power Management Products Division
200 Flynn Road, Camarillo, CA 93012
Semtech Corporation
20
10. If Schottky diode used in parallel with a synchronous
(bottom) FET, to achieve a greater efficiency at lower Vout
settings, it needs to be placed next to the aforementioned
FET in very close proximity.
11. Since the feedback path relies on the accurate sampling
of the output ripple voltage, the best results can be achieved
by connecting the AGND to the ground side of the bulk
output capacitors.
12. DRVGND pin should be tight to the main ground plane
utilizing very low impedance connection, e.g., multiple vias.
13. In order to prevent substrate glitching, a small (0.5A)
Schottky diode should be placed in close proximity to the
chip with the cathode connected to BOOTLO and anode
connected to DRVGND.
www.semtech.com
SC2655