ST24C02 ST Microelectronics, ST24C02 Datasheet - Page 11

• Manufacturer Part Number: ST24C02
• Description: SERIAL 2K (256 x 8) EEPROM
• Manufacturer: ST Microelectronics

Figure 9. Write Modes Sequence with Write Control = 1 (ST24/25W02)
Sequential Read. This mode can be initiated with
either a Current Address Read or a Random Ad-
dress Read. However, in this case the master
DOES acknowledge the data byte output and the
memory continues to output the next byte in se-
quence. To terminate the stream of bytes, the
master must NOT acknowledge the last byte out-
put, but MUST generate a STOP condition. The
output data is from consecutive byte addresses,
with the internal byte address counter automat-
WC
BYTE WRITE
WC
PAGE WRITE
WC (cont'd)
PAGE WRITE
(cont'd)
ACK
DEV SEL
DEV SEL
DATA IN N
R/W
R/W
ACK
ACK
ACK
BYTE ADDR
BYTE ADDR
ically incremented after each byte output. After a
count of the last memory address, the address
counter will ’roll- over’ and the memory will continue
to output data.
Acknowledge in Read Mode. In all read modes
the ST24/25x02 wait for an acknowledge during the
9th bit time. If the master does not pull the SDA line
low during this time, the ST24/25x02 terminate the
data transfer and switches to a standby state.
ST24/25C02, ST24C02R, ST24/25W02
ACK
ACK
DATA IN 1
DATA IN
ACK
ACK
DATA IN 2
AI01101B
11/16