T5753 ATMEL Corporation, T5753 Datasheet
![no-image](/images/manufacturer_photos/0/0/79/atmel_corporation_sml.jpg)
T5753
Available stocks
Related parts for T5753
T5753 Summary of contents
Page 1
... C Operation for Tire Pressure Systems Description The T5753 is a PLL transmitter IC which has been developed for the demands of RF low-cost transmission systems at data rates kBaud. The transmitting frequency range is 310 MHz to 330 MHz. It can be used in both FSK and ASK systems ...
Page 2
... Connection for crystal 6 VS Supply voltage 7 GND Ground 8 ENABLE Enable input T5753 2 1 CLK 2 PA_ENABLE T5753 ANT2 3 ANT1 4 /4 XTAL See ESD protection circuitry (see Figure 8 on page 8) See ESD protection circuitry (see Figure 8 on page 8) 8 ENABLE GND XTAL ...
Page 3
... This output configuration enables a simple matching to any kind of antenna high power efficiency /(I out an optimized load impedance of Z ENABLE 8 GND XTAL 5 XTO hence a 9.8438 MHz XTAL 3 ms until the CLK is used for the 40% for the power amplifier results when S, (255 + j192) is used supply voltage. Load T5753 3 ...
Page 4
... The clock of the crystal oscillator can be used for clocking the microcontroller. Atmel’s ATARx9x has the special feature of starting with an integrated RC-oscillator to switch on the T5753 with ENABLE = H, and after assume the clock signal of the transmis- sion IC, so that the message can be sent with crystal accuracy. ...
Page 5
... C achieve a better tolerance value and to have the possibility to realize the Z using standard valued capacitors. C forms together with the pins of T5753 and the PCB board wires a series resonance 1 st loop that suppresses the 1 harmonic, hence the position of C Normally the best suppression is achieved when C pins ANT1 and ANT2 ...
Page 6
... Figure 6. ASK Application Circuit PA_ENABLE C 2 Loop C 1 Antenna T5753 6 BPXY ATARx9x BPXY BPXY OSC1 7 T5753 Power up/down CLK PFD CP ANT2 3 LF ANT1 4 VCO PA PLL BPXY ENABLE 8 32 GND XTAL ...
Page 7
... C 1 Antenna 4510F–RKE–07/04 ATARx9x BPXY BPXY BPXY OSC1 7 T5753 Power up/down f CLK PFD CP ANT2 3 LF ANT1 4 VCO PA PLL BP42/T2O 18 BPXY ENABLE 8 32 GND XTAL XTAL 5 XTO T5753 ...
Page 8
... Exposure to absolute maximum rating conditions for extended periods may affect device reliability. Parameters Supply voltage Power dissipation Junction temperature Storage temperature Ambient temperature Input voltage Note 0.3 is higher than 3.7 V, the maximum voltage will be reduced to 3 Thermal Resistance Parameters Junction ambient T5753 8 ANT1 CLK PA_ENABLE ANT2 Symbol Minimum tot ...
Page 9
... XTO -30 f +30 XTAL -40 +40 250 -116 -110 -86 -94 -125 -121 f 310 330 VCO f /128 0 110 T5753 Unit nA 7 µ dBm 8.0 dBm dBc dBc ppm ppm kHz dBc/Hz -80 dBc/Hz -90 dBc/Hz dBc/Hz MHz MHz V 0 ...
Page 10
... FSK modulation frequency rate ASK modulation frequency rate ENABLE input PA_ENABLE input Note higher than 3.6 V, the maximum voltage will be reduced to 3 T5753 All parameters are referred to GND (pin 7). amb Test Conditions Duty cycle of the modulation signal = 50% Duty cycle of the modulation signal = ...
Page 11
... Ordering Information Extended Type Number T5753-6AQ Package Information 4510F–RKE–07/04 Package Remarks TSSOP8L Taped and reeled, Marking: T573 T5753 11 ...
Page 12
... Revision History Changes from Rev. 4510E-RKE-10/03 to Rev. 4510F-RKE-07/04 T5753 12 Please note that the following page numbers referred to in this section refer to the specific revision mentioned, not to this document. 1. Abs. Max. Ratings table (page 8): row “Input voltage” added 2. Abs. Max. Ratings table (page 8): table note 1 added 3. El. Char. table (page 10): row “ ...
Page 13
... Fax: (81) 3-3523-7581 Disclaimer: Atmel Corporation makes no warranty for the use of its products, other than those expressly contained in the Company’s standard warranty which is detailed in Atmel’s Terms and Conditions located on the Company’s web site. The Company assumes no responsibility for any errors which may appear in this document, reserves the right to change devices or specifications detailed herein at any time without notice, and does not make any commitment to update the information contained herein ...