ISL6144 Intersil Corporation, ISL6144 Datasheet - Page 14

• Manufacturer Part Number: ISL6144
• Description: High Voltage ORing MOSFET Controller
• Manufacturer: Intersil Corporation

ISL6144 Evaluation Board Overview
This section of the datasheet serves as an instruction
manual for the ISL6144EVAL1 board. It also provides design
guidelines and recommendations for using the ISL6144 for
ORing MOSFET control. The ISL6144EVAL1 Control Board
has two parallel feeds connected to each other through
N-channel ORing MOSFETs. Each ORing MOSFET has an
ISL6144 connected to it. This board demonstrates the
operation of Intersil’s ISL6144 HV ORing MOSFET
Controller IC in a typical 1 + 1 redundant power system.
To demonstrate the functionality of the ISL6144, two power
supplies with identical output voltages are required as the
input to the ISL6144EVAL1 board. This will show the ability
of the ISL6144 to provide the gate drive voltage for the
ORing N-Channel MOSFET. The ISL6144 also monitors the
drain (V
provide reverse current protection and protection against
power feeds’ related faults.
Figure 17 shows a test setup used in the characterization of
ISL6144 in a 1 + 1 redundant power system.
ISL6144EVAL1 Control Board (Rev C)
This board is configured with two input power feeds
connected in parallel for redundancy using ORing
MOSFETs. The ISL6144 allows the two rails to operate in
active ORing mode (This means that both feeds can share
the current if their respective voltages are close to each
OUT
), source (V
DC/DC CONVERTERS (NOT PART OF THE EVAL BOARD)
IN
) and gate voltages in order to
14
FIGURE 16. TEST SETUP USING DC/DC MODULES
ISL6144
other). ORing MOSFET’s gate drive voltage, control and
monitoring for each of these feeds are implemented using
the ISL6144.
The board has the following features:
• Evaluation of the ISL6144 in a 1 + 1 redundant power
• Has footprint for a total of three parallel MOSFETs per
• Allows the user to test turn-on, slow turn-off, fast turn-off
• Visual fault indication with Red LEDs
• Banana Connectors and test points for all inputs, outputs
• Can be easily connected to the power system prototype
Note that the board was designed to handle high load
currents (up to 20A per feed) with the appropriate MOSFET
selection.
system using a single board
feed. Number of MOSFETs used will depend on the load
current (on the standard ISL6144EVAL1 board only one
MOSFET is populated per feed)
and different fault scenarios
and IC pins
for initial evaluation
ISL6144EVAL1 CONTROL BOARD
February 15, 2007
FN9131.3