4462-SNA 3M, 4462-SNA Datasheet - Page 2

• Manufacturer Part Number: 4462-SNA
• Description: SHIELD CONNECTOR WITH SHOE
• Manufacturer: 3M
• Series: 4462r

Specifications of 4462-SNA

• Accessory Type: Shielding Shoe
• For Use With/related Products: Shielded Cables
• Lead Free Status / RoHS Status: Lead free / RoHS Compliant
• Features: -
• Other names: 0-00-54007-57157-5; 00054007571575; 3M9056; 4462SNA; 5400757157; 54007571575; 80-6105-8211-8; 80610582118

3M TelComm Products Division
6801 River Place Blvd.
Austin, TX 78726-9000
4.0 Cable Preparation
Note: For both single and double sheath cables, cut
4.01 Single Sheath Cable
Note: On cables less than 3/4" (19 mm) in diameter,
Important Notice - Before utilizing the product the user should determine the suitability of the product for its intended use. The
user assumes all risks and liability in connection with such use. 3M'S WRITTEN WARRANTY FOR THE PRODUCT IS MADE
IN LIEU OF ALL OTHER WARRANTIES, EXPRESSED OR IMPLIED, INCLUDING BUT NOT LIMITED TO THE IMPLIED
WARRANTIES OF MERCHANTABILITY AND FITNESS FOR A PARTICULAR PURPOSE. The user's exclusive remedy for
breach of 3M's written warranty shall be the repair or replacement of such quantity of product which is proven to be defective.
In no case shall 3M be liable for any special, incidental, or consequential damages based upon breach of warranty, breach of
contract, negligence, strict liability or any other legal theory.
34-7030-6666-1
4.02 Double Sheath Cable
4.04 Make a 1" (25 mm) slit in the outer sheath and
4.03 When using the 4462-SNA on single sheath
shield. Lift corners for base insertion.
cable, insert the insulating shoe between the
core wrap and shield.
Core Wrap
1/8" (3 mm)
shield flush with the outer sheath.
cut a 1 1/2" (38 mm) slit in the sheath opposite
connector location. Then complete
procedure.
Core Wrap
1" (25 mm) Slit
(13 mm)
1/2"
Inner Sheath
1 1/2" (38 mm) Slit
1/2" (13 mm)
1" (25 mm) Slit
Cable Sheath
Outer Sheath
893836
893836
842946
893788
893788
1991 3M
5.0 Installation
5.01 Insert connector base between shield and
Note: Tail of base must contact connector top.
5.04 Place bond conductor (strap, bar, wire, or
5.02 Place terminal wrench over stud and push
5.03 Place connector top over stud and tighten
insulating shoe or core wrap; inner sheath for
double sheath cable, until stops meet outer
sheath.
braid) over stud and secure in place with nut
supplied.
down to bend corners and pull slit together.
firmly with securing nut.
Stops
Litho in U.S.A.
893837
893837
893837
893837