IRA-E900ST1 Murata Manufacturing Co., Ltd, IRA-E900ST1 Datasheet - Page 20

• Manufacturer Part Number: IRA-E900ST1
• Description: Pyroelectric Infrared Sensors
• Manufacturer: Murata Manufacturing Co., Ltd

Note
• This PDF catalog is downloaded from the website of Murata Manufacturing co., ltd. Therefore, it’s specifications are subject to change or our products in it may be discontinued without advance notice. Please check with our
• This PDF catalog has only typical specifications because there is no space for detailed specifications. Therefore, please approve our product specifications or transact the approval sheet for product specifications before ordering.
sales representatives or product engineers before ordering.
▊
1. Caution (Design)
(1) Please make sure that your product has been evaluated
(2) Be sure to provide an appropriate fail-safe function on
(3) In case of outdoor use, suitable optical filter and water
(4) To prevent failure or malfunction, please use a stabilized
(5) Please avoid using the sensor in the following conditions
18
Notice
and confirmed against your specifications when our
product is mounted to your product.
your product to prevent a second damage that may be
caused by the abnormal function or the failure of our
product.
and humidity proof structure should be applied.
power supply.
because it may cause failure or malfunction.
(a) in such a fluid as water, alcohol etc. corrosive gas
(b) in high humidity
(c) in a place exposed directly to sunlight or headlights of
(d) in a place exposed to rapid ambient temperature
(e) in a place exposed directly to an air-conditioner or
(f) strong vibrations
(g) in a place exposed to strong electromagnetic field
(h) in such a place where infrared ray is shaded
(i) in any other place similar to the above (a) through (h)
(SO
automobile
change
heat vent
2
, Cl
2
, NO
X
etc.) or sea breeze
2. Caution (Handling and Storage)
(1) The optical filter of the sensor should not be scratched or
(2) Strong shock should be avoided.
(3) Electrostatics and strong electromagnetic field should be
(4) The sensor should be kept on conductive sponge.
(5) High temperature, high humidity, fluid such as water or
soiled.
avoided.
alcohol etc., corrosive gas (SO
breeze should be avoided.
2
, Cl
2
, NO
X
etc.) and sea
Notice
P17E.pdf
10.11.1