BHC-DN2P2E Everlight Electronics Co., Ltd., BHC-DN2P2E Datasheet - Page 10

• Manufacturer Part Number: BHC-DN2P2E
• Description: Chip LED
• Manufacturer: Everlight Electronics Co., Ltd.

4.Soldering Iron
within once in less than the soldering iron capacity 25W. Leave two seconds and more intervals, and do
soldering of each terminal. Be careful because the damage of the product is often started at the time of
the hand solder.
5.Repairing
a double-head soldering iron should be used (as below figure). It should be confirmed beforehand
whether the characteristics of the LEDs will or will not be damaged by repairing.
EVERLIGHT ELECTRONICS CO., LTD.
Office: No 25, Lane 76, Sec 3, Chung Yang Rd,
Everlight Electronics Co., Ltd.
Device No. : DSE-235-002
Tucheng, Taipei 236, Taiwan, R.O.C
Repair should not be done after the LEDs have been soldered. When repairing is unavoidable,
Each terminal is to go to the tip of soldering iron temperature less than 350℃ for 3 seconds
EVERLIGHT ELECTRONICS CO.,LTD.
http://www.everlight.com
Prepared date: 6-Mar-2007
Tel: [phone]
Fax: [phone]
http://www.everlight.com
23-215A/BHC-DN2P2E/5A
Rev. 2
Prepared by: Jay Chou
Page: 10 of 10