BHC-APR Everlight Electronics Co., Ltd., BHC-APR Datasheet - Page 9

• Manufacturer Part Number: BHC-APR
• Description: Chip LED with Inner Lens
• Manufacturer: Everlight Electronics Co., Ltd.

1. Over-current-proof
2. Storage
3. Soldering Condition
4.Soldering Iron
within once in less than the soldering iron capacity 25W. Leave two seconds and more intervals, and
do soldering of each terminal. Be careful because the damage of the product is often started at the time
of the hand solder.
Precautions For Use
2.1 Do not open moisture proof bag before the products are ready to use.
2.2 Before opening the package: The LEDs should be kept at 30℃ or less and 90%RH or less.
2.3 After opening the package: The LEDs should be kept at 30℃ or less and 70%RH or less(Floor
life). However, it’s recommended that the LEDs should be used within 168 hours(7 days) after opening
the package.If unused LEDs remain, it should be stored in moisture proof packages.
2.4 If the moisture absorbent material (silica gel) has faded away or the LEDs have exceeded the
storage time, baking treatment should be performed using the following conditions.
Baking treatment : 60±5℃ for 24 hours.
3.1 Pb-free solder temperature profile
3.2 Reflow soldering should not be done more than two times.
3.3 When soldering, do not put stress on the LEDs during heating.
3.4 After soldering, do not warp the circuit board.
Everlight Electronics Co., Ltd.
Device No.: SZDSE-251-B01
Customer must apply resistors for protection, otherwise slight voltage shift will cause big
current change ( Burn out will happen ).
Each terminal is to go to the tip of soldering iron temperature less than 350℃ for 3 seconds
EVERLIGHT ELECTRONICS CO.,LTD.
http://www.everlight.com
Prepared date: 3-Mar.-2005
Prepared by: Mao-Jinru
Rev. 1
25-21/BHC-APR/2A
Page: 9 of 10