EM-1RI Systemsensor, EM-1RI Datasheet - Page 2

• Manufacturer Part Number: EM-1RI
• Description: Relay Module
• Manufacturer: Systemsensor

www.DataSheet4U.com
FIGURE 2: WIRING DIAGRAM:
System Sensor warrants its enclosed module to be free from defects in materials and
workmanship under normal use and service for a period of three years from date of
manufacture. System Sensor makes no other express warranty for this module. No agent,
representative, dealer, or employee of the Company has the authority to increase or
alter the obligations or limitations of this Warranty. The Company’s obligation of this
Warranty shall be limited to the repair or replacement of any part of the module which
is found to be defective in materials or workmanship under normal use and service
during the three year period commencing with the date of manufacture. After phoning
System Sensor’s toll free number 800-SENSOR2 (736-7672) for a Return Authorization
number, send defective units postage prepaid to: System Sensor, Returns Department, RA
This device complies with part 15 of the FCC Rules. Operation is subject to the following two conditions: (1) This device may not cause harmful interference, and (2) this device must
accept any interference received, including interference that may cause undesired operation.
NOTE: This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant to Part 15 of the FCC Rules. These limits are designed to provide
reasonable protection against harmful interference in a residential installation. This equipment generates, uses and can radiate radio frequency energy and, if not installed and used
in accordance with the instructions, may cause harmful interference to radio communications. However, there is no guarantee that interference will not occur in a particular installa-
tion. If this equipment does cause harmful interference to radio or television reception, which can be determined by turning the equipment off and on, the user is encouraged to try
to correct the interference by one or more of the following measures:
D500-61-00
CONTACTS
RELAY
{
– Reorient or relocate the receiving antenna.
– Increase the separation between the equipment and receiver.
– Connect the equipment into an outlet on a circuit different from that to which the receiver is connected.
– Consult the dealer or an experienced radio/TV technician for help.
LIMITED. TERMINALS 7-12 ARE
VISE CONTROLLED CIRCUITS.
MODULE DOES NOT SUPER-
TERMINALS 1-6 ARE POWER
NOTE: NORMALLY OPEN OR
NORMALLY CLOSED CONTACT
DEVICE (NOT SUPERVISED).
NOTE: NORMALLY CLOSED
OPTION MAY NOT BE USED
FOR FIRE APPLICATIONS.
NON-POWER LIMITED.
12
10
11
7
9
8
TWISTED PAIR RECOMMENDED AND IS POWER
1
2
3
4
5
6
SIGNAL LINE CIRCUIT (SLC)
LIMITED AND SUPERVISED
ThREE-YEAR LIMITED WARRANTY
30 VDC MAX.
)
)
)
)
( +
( +
( –
( –
NORMALLY CLOSED (T10)
FCC STATEMENT
NORMALLY CLOSED (T7)
NORMALLY OPEN (T12)
NORMALLY OPEN (T9)
2
#__________, 3825 Ohio Avenue, St. Charles, IL 60174. Please include a note describing
the malfunction and suspected cause of failure. The Company shall not be obligated to
repair or replace units which are found to be defective because of damage, unreasonable
use, modifications, or alterations occurring after the date of manufacture. In no case shall
the Company be liable for any consequential or incidental damages for breach of this
or any other Warranty, expressed or implied whatsoever, even if the loss or damage is
caused by the Company’s negligence or fault. Some states do not allow the exclusion or
limitation of incidental or consequential damages, so the above limitation or exclusion
may not apply to you. This Warranty gives you specific legal rights, and you may also
have other rights which vary from state to state.
COMMON (T11)
COMMON (T8)
)
)
)
)
( +
( +
( –
( –
CONTROL PANELS ONLY
TO LISTED COMPATIBLE
CONNECT MODULES
PREVIOUS PANEL
FROM PANEL OR
TO NEXT DEVICE
©2007 System Sensor
CONTACT #2
CONTACT #1
RELAY
RELAY
I56-2023-005
C0110-02